Print Page | Close Window

93 Buick Skylark Remote Start Info

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=70981
Printed Date: July 13, 2025 at 7:15 AM


Topic: 93 Buick Skylark Remote Start Info

Posted By: tankisarockstar
Subject: 93 Buick Skylark Remote Start Info
Date Posted: January 17, 2006 at 3:07 PM

I have a 93 Buick Syklark with an aftermarket Viper alarm. I want to put the Valet 562T remote start in myself..anyone have the proper wiring diagrams?



Replies:

Posted By: ahdol
Date Posted: January 17, 2006 at 3:30 PM




Posted By: thepencil
Date Posted: January 20, 2006 at 8:57 AM


DIRECTWIRE™ WIRING INFORMATION - BUICK / SKYLARK / 1993 / Remote Start



12volts red    +   ignition harness
Starter yellow    +   ignition harness
Second Starter          
Ignition pink    +   ignition harness
Second Ignition pink/white    +   ignition harness
Third Ignition          
Accessory orange    +   ignition harness
Second Accessory          
Keysense          
Power Lock lt. blue    +   drivers kick
Power Unlock black    +   drivers kick
Lock Motor          
Unlock Motor          
Parking Lights+ brown      light switch
Parking Lights-          
Hazards          
Turn Signal(L)          
Turn Signal(R)          
Reverse Light          
Door Trigger white    -   courtesy lt, pinswitch
Dome Supervision          
Trunk/Hatch Pin          
Hood Pin          
Trunk/Hatch Release black    +   release switch
Power Sliding Door          
Factory Alarm Arm          
Factory Alarm Disarm          
Disarm No Unlock          
Tachometer PURPLE / white   AC   distributor/coil pack
Notes: Some coil packs rear of engine above transaxle.
Wait to start          
Brake Wire white    +   brake switch
Parking Brake          
Horn Trigger black    -   steering column
Memory Seat 1          
Memory Seat 2          
Memory Seat 3          
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image





Print Page | Close Window