Acura Legend Amp Wiring

I am looking to wire my 91' legend myself, however I do not know where exactly I should run the wiring (how to get it from the engin bay to the interioir of the car).  If anyone can help with my predicament it would be much appreciated.

- Sean Henderson

I usually run my power down the driver side of the car.  I will run my rcas down the passenger side of the car.  By doing this you are keeping your rcas from picking up engine noise.  I take the driver side door still plate off first.  That will let you pull your carpet back a little.  Then (if it is in the way) remove your kickpanel(on the driver side).  Look under the dash for unused rubber gromments to pass your power cable through.  Most of the time you can find one.  If not, you need to drill a hole through the firewall.  Look 3 times and then look again,before you drill.  Make sure you are clear of all moving parts, exhuast, ect...  Drill your hole and then use some silicone cualk to weather proof the hole.  That all there is too it.  Take your time and good luck with the install.   Brian