Print Page | Close Window

2000 Nissan Xterra Alarm

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74349
Printed Date: July 12, 2025 at 5:58 PM


Topic: 2000 Nissan Xterra Alarm

Posted By: paragon
Subject: 2000 Nissan Xterra Alarm
Date Posted: March 12, 2006 at 2:29 PM

Everyone,

Does anyone have any idea as to what color the dome lite supervision wire in a 2000 Nissan Xterra would be?  Due to the dome lite time-out, I am getting a second chirp (open zone) unless I allow the dome lite to time out.  I cannot find the wire that controls this in the kick panel, and was wondering if anyone had any insight on this.  Thank you for your help.




Replies:

Posted By: Hornshockey
Date Posted: March 12, 2006 at 2:47 PM
I'm assuming that you're looking for the door trigger wire instead of the domelight supervision wire.

On vehicles without power door locks use RED / black at any door switch or also found in the driver A pillar. Vehicles with power door locks use GREEN/ red for the driver door, GREEN/ black for the front passenger door, and RED / black for the rear doors. All found at the smart entrance control unit, use all three and diode isolate each. Smart Entrance Control Unit is above the hood release in the drivers kick panel.

So I'm guessing you have power locks since you have the domelight time out feature. Use the three individual door triggers, it will provide you a good signal to the alarm regardless of whether the domelight is on or not.

-------------
Life moves pretty fast; if you don't stop and look around once in a while; you could miss it.


Print Page | Close Window