Print Page | Close Window

2006 Mazda 6 Alarm/Remote Start, Stereo Wiring

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=78742
Printed Date: March 28, 2024 at 7:56 AM


Topic: 2006 Mazda 6 Alarm/Remote Start, Stereo Wiring

Posted By: cybreyor
Subject: 2006 Mazda 6 Alarm/Remote Start, Stereo Wiring
Date Posted: June 05, 2006 at 10:57 AM

I've looked everywhere and can't find the wiring for a 06 Mazda 6 (without bose) All I really need is the radio, but auto start diagram is appreciated too. Thank you!



Replies:

Posted By: djfearny2
Date Posted: June 05, 2006 at 11:01 AM
[PRINT THIS PAGE]


12volts black (40A), BLACK/ yel (30A)   +   ignition harness
Starter BLACK/ blue   +   ignition harness
Second Starter N/A       
Ignition blue   +   ignition harness
Second Ignition N/A       
Third Ignition N/A       
Accessory BLACK/ red   +   ignition harness
Second Accessory BLACK/ white   +   ignition harness
Keysense WHITE/ blue   +   ignition harness
Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.
Power Lock lt. green   -   driver kick or door lock module
Notes: Lock is negative trigger thru a 1000 ohm resistor. Unlock is a straight negative trigger. MUST use relays.

The door lock control module is located above the passenger kick panel.
Power Unlock same as power lock wire       
Lock Motor RED / blue   5wi driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Unlock Motor RED / green   5wi driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Parking Lights+ lt. GREEN/ black   +   driver kick, 14 pin plug
Parking Lights- RED / white   -   headlight switch
Hazards blue/orange   -   switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Turn Signal(L) WHITE/ black   +   turn signal switch
Turn Signal(R) WHITE/ red   +   turn signal switch
Reverse Light RED / yellow   +   driver kick, 14 pin plug
Door Trigger GREEN/ orange   -   driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Dome Supervision yellow/black   -   driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Trunk/Hatch Pin brown   -   driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Hood Pin gray/red   -   pin switch or theft module
Notes: The theft-deterrent control module is located in the center console.
Trunk/Hatch Release yellow   -   switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Power Sliding Door N/A       
Factory Alarm Arm blue   -   driver kick or door lock module
Notes: Arm is negative trigger thru a 1000 ohm resistor. Disarm is a straight negative trigger. MUST use relays.

The door lock control module is located above the passenger kick panel.
Factory Alarm Disarm same as factory alarm arm wire       
Disarm No Unlock use key sense wire       
Tachometer NOT blk/wht or grn/stripe   ac   any ignition coil or coil pack
Notes: On the 4 cyl models use the wire that is NOT BLACK/ white. On the 6 cyl models use the wire that is NOT GREEN/ stripe.
Wait to start N/A       
Brake Wire GREEN/ YELLOW   +   brake pedal switch
Parking Brake brown   -   parking brake switch
Horn Trigger PURPLE / white   -   switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 1100F
Alternate Part1 #: 556UW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes: Standard on all models.
Interface Module: Category:
Door Lock Interface Required:
Yes Type:
Multiplex
Part #: 456LW
Notes:
Smart Starter Kill Relays: Relay Type:
Starter Relay Location:
Engine compartment fusebox, Driver side
Part #: 6403A

this is for a 2005 but it should be the same.

Radio: Radio 12v
blue/red
+
radio harness
   

Radio Ground BLACK/ orange or BLACK / YELLOW   -   radio harness     
Radio Ignition orange   +   radio harness     
Radio Illumination lt. GREEN/ red   +   radio harness     
Factory Amp Turn-on blue/black   +   radio harness     
Power Antenna N/A           
LF Speaker +/- red - white   +,- radio harness or amp under pass seat    
RF Speaker +/- blue - yellow   +,- radio harness or amp under pass seat    
LR Speaker +/- purple - pink   +,- radio harness or amp under pass seat    
RR Speaker +/- WHITE/ blue - BLACK/ blue   +,- radio harness or amp under pass seat    


Interface Modules


-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.




Posted By: cybreyor
Date Posted: June 05, 2006 at 11:27 AM
Thank you for the reply. I did have the 2005 guide and the wire colors vary. IE: There is no BLACK/ orange wire on either harness.





Print Page | Close Window