Print Page | Close Window

Program GM factory remote.

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=7931
Printed Date: May 14, 2025 at 7:41 AM


Topic: Program GM factory remote.

Posted By: jrilla
Subject: Program GM factory remote.
Date Posted: January 10, 2003 at 9:18 AM

Anyone have the instructions on how to program a GM factory remote. I have a 1997 Oldsmobile 88 if that makes any difference.

-------------
J Rilla

Owner/Installer



Replies:

Posted By: jrilla
Date Posted: January 12, 2003 at 11:14 AM
Someone has to know how to do this out there.

-------------
J Rilla

Owner/Installer



Posted By: Velocity Motors
Date Posted: January 12, 2003 at 12:09 PM

Hey J, try this procedure ( note that this is for a Pontiac but I'm sure it's the same for most GM's )

1997-98 Grand Prix

1.        Sit in driver's seat.

2.        Remove ignition key from lock cylinder.

3.        Ensure all doors are closed.

4.        Remove the "MALL PGM" fuse from fuse panel.

5.        Turn ignition lock cylinder to accessory position.

6.        Turn ignition lock cylinder to off position and then back to accessory position within one second.

7.        Open and close any door. A chime will be heard when remote control door lock receiver enters programming/diagnostic mode. If chime is not heard, repeat procedure as necessary.

8.        Press and hold remote transmitter lock and unlock buttons for 14 seconds.

9.        After 7 seconds, a chime should be heard confirming successful synchronization. After 14 seconds, a chime will be heard confirming successful programming.

10.     Repeat step 8 for each additional transmitter.

11.     Remove ignition key from ignition lock cylinder.

12.     Install "MALL PGM" fuse to fuse panel.



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: jrilla
Date Posted: January 12, 2003 at 3:38 PM
Thanks Jeff, I will give it a shot and let you know how it turns out.

-------------
J Rilla

Owner/Installer


Print Page | Close Window