trying to installAvistart 3200 in a 2000 ford explorer with keyless entry and PATS system need diagram
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|yellow |+ |ignition harness |
| STARTER|RED / lt. blue |+ |ignition harness |
| IGNITION|GREEN/ purple *1 |+ |ignition harness |
| ACCESSORY|gray / YELLOW *1 |+ |ignition harness |
| SECOND ACCESSORY|BLACK/ green |+ |ignition harness |
| POWER LOCK|pink / YELLOW |- |driver's kick panel |
| POWER UNLOCK|pink/green |- |driver's kick panel |
| LOCK MOTOR|pink/black | |driver's kick panel |
| UNLOCK MOTOR|RED / orange | |driver's kick panel |
| DISARM DEFEAT|pink/orange *2 | |driver's kick panel |
| PARKING LIGHTS +|PURPLE / white *3 | |driver's kick panel |
| PARKING LIGHTS -|WHITE/ purple | |driver's kick panel |
| HEADLIGHTS|RED / yellow |+ |light switch |
| DOOR TRIGGER|*4 |- |*4 |
| DOME SUPERVISION|use door trigger | | |
| TRUNK/HATCH PIN|WHITE/ purple |- |driver's kick panel |
| HOOD PIN|tan/lt.green |- |driver's kick panel |
| FCTRY ALARM ARM|arms on lock *5 | | |
|FCTRY ALRM DISARM|dk. GREEN/ purple |- |driver's kick panel |
| TACHOMETER|tan / YELLOW | |PCM *6 |
| SPEED SENSE|gray/black |8 |PCM *6 |
| BRAKE WIRE|lt.green |+ |driver's kick, brake switch |
| HORN TRIGGER|yellow/lt. green |- |steering column |
| WIPERS|wht & dk.blu/org *7 |+ |wiper motor or relay |
| LF WINDOW UP/DN|wht/blk - red |A |at motor in dr door |
| RF WINDOW UP/DN|wht/yel - tan/lt.blu|A |sw dr door or dr kick |
| LR WINDOW UP/DN|gry/org - yel/lt.blu|A |sw dr door or dr kick |
| RR WINDOW UP/DN|yel/blk - RED / blk |A |sw dr door or dr kick |
| POWER ANTENNA|lt GREEN/ purple |+ |radio |
Notes:
NOTE: Some models of this vehicle are equipped with PATS (Passive Anti Theft System). Use PKF keyless bypass module or go here ( Ford PATS I, PATS II & EPATS Bypass ) for a key required bypass . *1 Two wires each at switch, both are common, only need to power 1 each during remote start. *2 You may also use the pink/green power unlock wire. *3 Also found to be WHITE/ black at the rear of the switch. *4 In the drivers door harness find yellow/black for the drivers door. In the drivers kick panel find lt. GREEN/ YELLOW for the drivers rear door. In the passengers kick panel find gray/red for the passenger front door, and pink/lt. blue for the passengers rear door. All four wires are negative trigger and must be diode isolated together. Refer to directfax document #1076 for wiring information. *5 Arms on lock only with door open. It is necessary to send a signal to door trigger as well as lock to arm factory alarm. *6 The PCM is located at the top of the firewall towards the passenger side, the tan / YELLOW tach wire is also found at the back of the instrument cluster. *7 Also found yellow/white (-) at the firewall connector.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA