2007 Toyota FJ Cruiser Audio/Alarm Wiring
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83096
Printed Date: May 02, 2025 at 6:18 PM
Topic: 2007 Toyota FJ Cruiser Audio/Alarm Wiring
Posted By: Viper238
Subject: 2007 Toyota FJ Cruiser Audio/Alarm Wiring
Date Posted: September 19, 2006 at 2:51 PM
audio wiring info.. mainly interested in the amp wiring in the rear quarter panel.. I found out on the audiovox site that that's where it is located.. but no specific info on signal or power.. The vehicle is able to have a amp and sub as I've been told.. I found the harness.. but haven't had time to try and figure out what is what.. I believe there is 7 or 8 wires in the plug.. Thanks
Replies:
Posted By: Viper238
Date Posted: October 12, 2006 at 9:24 AM
Any updates?
Posted By: eliteaudioplus
Date Posted: October 30, 2006 at 1:15 PM
any alarm diagrams for 07 toyota fj
Posted By: Big Dog
Date Posted: October 30, 2006 at 3:06 PM
Does this help? Radio 12v
| Radio Ground | Radio Ignition | Radio Illumination | Factory Amp Turn-on | Power Antenna | LF Speaker +/- | RF Speaker +/- | LR Speaker +/- | RR Speaker +/- |
I don't know how to interface with the NXT roof liner flat panel speakers. https://www.nxtsound.com/index.php?id=648 ------------- Prepare your future. It wasn't the lack of stones that killed the stone age.
Posted By: Big Dog
Date Posted: October 30, 2006 at 3:10 PM
Here's the r-start info: ITEM WIRE COLOR POLARITY LOCATION 12volts | wht/blue (50A), blue/blk (30A) | + | ignition harness | Starter | GREEN/ black | + | ignition harness | Second Starter | BLACK/ white | + | ignition harness | Ignition | BLACK/ red | + | ignition harness | Second Ignition | blue / YELLOW | + | ignition harness | Third Ignition | N/A | | | Accessory | WHITE/ green | + | ignition harness | Second Accessory | N/A | | | Keysense | GREEN/ YELLOW | - | ign harn or BECU, top plug, pin 14 | Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.
The Body ECU is attached to the back of the fuse box under the driver side dash. It has three plugs on the right side edge of the fuse box. | Power Lock | blue | - | driver kick, 18 pin plug, pin 6 | Notes: Meter this wire while turning the key in the driver door key cylinder. | Power Unlock | pink (double pulse) | - | driver kick, 18 pin plug, pin 8 | Notes: Meter this wire while turning the key in the driver door key cylinder.
Also found at the BECU, bottom plug, pin 12.
Can also use the passenger door key cylinder unlock wire, which only requires a single pulse. It is YELLOW /GREEN in the passenger kick, 18 pin plug, pin 3 or at the BECU, bottom plug, pin 22.
The Body ECU is attached to the back of the fuse box under the driver side dash. It has three plugs on the right side edge of the fuse box. | Lock Motor | blue/red to BLACK/ white | 5wi | driver kick, 13 pin plug, pin 8 | Unlock Motor | blue/black to BLACK/ red | 5wi | driver kick, 13 pin plug, pin 13 | Parking Lights+ | green | + | BECU, bottom plug, pin 28 | Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. It has three plugs on the right side edge of the fuse box.
Also found at the fuse box, 16 pin plug, pin 13. | Parking Lights- | green | - | switch or BECU, top plug, pin 8 | Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. It has three plugs on the right side edge of the fuse box. | Hazards | white | - | hazard switch | Turn Signal(L) | blue/white | + | fuse box, 16 pin plug, pin 9 | Turn Signal(R) | pink | + | fuse box, 16 pin plug, pin 15 | Reverse Light | RED / yellow | + | fuse box, 16 pin plug, pin 10 | Door Trigger | purple / YELLOW (ajar indicator) | - | BECU, top plug, pin 12 | Notes: The individual door trigger wires are also available at the BECU, in the middle plug. The LF door is RED / black in pin 23. The RF door is GREEN/ YELLOW in pin 24. The LR door is pink/black in pin 11. The RR door is pink/blue in pin 12. Use all four wires and diode isolate each.
The Body ECU is attached to the back of the fuse box under the driver side dash. It has three plugs on the right side edge of the fuse box. | Dome Supervision | white | - | fuse box, 20 pin plug, pin 8 | Trunk/Hatch Pin | white | - | BECU, middle plug, pin 7 | Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. It has three plugs on the right side edge of the fuse box. | Hood Pin | N/A | | | Trunk/Hatch Release | blue / YELLOW | 5wi | back door ECU, 25 pin plug, pin 13 | Notes: The back door ECU is in the rear tailgate. | Power Sliding Door | N/A | | | Factory Alarm Arm | arms with lock | | | Factory Alarm Disarm | disarms with unlock | | | Disarm No Unlock | use key sense wire | | | Tachometer | BLACK/ white | ac | data link conn. under dash, pin 9 | Notes: Also found at the ECM (Engine Control Module) behind the glovebox, second plug from the bottom, pin 1.
Can also go to any ignition coil and use the wire that is NOT BLACK/ red, WHITE/ red, or WHITE/ black.
Can also go to any fuel injector and use the wire that is NOT BLACK/ red. | Wait to start | N/A | | | Brake Wire | GREEN/ YELLOW | + | sw or fuse box, 16 pin plug, pin 16 | Parking Brake | WHITE/ red | - | sw or fuse box, 24 pin plug, pin 1 | Horn Trigger | GREEN/ red | - | horn switch | Memory Seat 1 | N/A | | | Memory Seat 2 | N/A | | | Memory Seat 3 | N/A | | |
Interface Module: | Category: Immobilizer Bypass | Required: No |
|
------------- Prepare your future. It wasn't the lack of stones that killed the stone age.
Posted By: eliteaudioplus
Date Posted: October 30, 2006 at 3:51 PM
Thanks for the post.
Posted By: netvoltage
Date Posted: November 25, 2006 at 6:22 PM
any info on the Nuetral Safety Switch wire for FJ Cruiser?
|