Print Page | Close Window

2006 jeep commander, alarm/rs

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83440
Printed Date: May 04, 2024 at 4:42 PM


Topic: 2006 jeep commander, alarm/rs

Posted By: spl_competitor
Subject: 2006 jeep commander, alarm/rs
Date Posted: September 27, 2006 at 9:21 PM

whats up ive got a 2006 jeep commander i am doing and alarm on - can anyone help me with the wiring colors for a remote start alarm and the model number for the DEI bypass module



Replies:

Posted By: shaggy12volt
Date Posted: September 27, 2006 at 10:23 PM
Here you go hope this helps you out if you need the dirct fax i will have to email them to you so i will need you email if you want them
 
 WIRING INFORMATION - JEEP / COMMANDER / 2006 / Remote Start

12volts lt. blue/red (20A)  +  ignition harness
Starter pink/orange  +  ignition harness
Second Starter PURPLE / brown  -  ignition harness
Notes: The second starter wire is negative trigger thru a 150 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.
Ignition pink/lt. green  +  ignition harness
Second Ignition N/A    
Third Ignition N/A    
Accessory same as second starter wire  -  ignition harness
Notes: The accessory wire is negative trigger thru a 560 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.
Second Accessory N/A    
Keysense N/A    
Power Lock PURPLE / dk. green  -  driver door module in door
Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays.

Can also use the trigger wires for the door lock relays found at the instrument cluster, conn. 2. Lock is lt. GREEN/ dk. green in pin 5. Driver door unlock is tan/lt. green in pin 6. Passenger door unlock is PURPLE / lt. green in pin 7.
Power Unlock same as power lock wire    
Lock Motor lt. GREEN/ lt. blue  5wi plug above fuses, pin 36
Unlock Motor lt. GREEN/ dk. green  5wi plug above fuses, pin 35
Parking Lights+ do not use, relay rests at gnd   
Parking Lights- (CAN data bus)    
Hazards WHITE/ dk. blue to WHITE/ tan  -  SCM, 16 pin plug, pin 16
Notes: The SCM (Steering Column Module) is in the steering column.
Turn Signal(L) use hazards wire    
Turn Signal(R) use hazards wire    
Reverse Light WHITE/ lt. green  +  IPM , conn. 2, pin 2
Notes: The IPM (Integrated Power Module) is on the driver fender, behind the battery.
Door Trigger see notes  -  each kick or cluster, conn. 3
Notes: The LF door is purple in pin 6. The RF door is PURPLE / white in pin 7. The LR door is PURPLE / gray in pin 4. The RR door is purple / YELLOW in pin 5. Use all four wires and diode isolate each wire from each other and the control module. Refer to DirectFax 1076 for wiring information.

Dome Supervision yellow/orange  -  any light or cluster, conn 2, pin 12
Trunk/Hatch Pin pur/org and pur/brn (glass)  -  DKP or cluster, conn. 3, pins 3, 2
Hood Pin N/A    
Trunk/Hatch Release ORANGE / purple  -  DKP or cluster, conn. 3, pin 8
Notes: Meter this wire while opening the rear glass from the switch on the rear hatch.

The hatch release motor wire is ORANGE / gray (5wi) at the plug above the fuses, pin 25.
Power Sliding Door N/A    
Factory Alarm Arm factory remote only    
Factory Alarm Disarm factory remote only    
Disarm No Unlock with ignition and Sentry Key    
Tachometer NOT RED / tan or dk. grn/lt. grn ac  any ignition coil or fuel injector
Wait to start N/A    
Brake Wire WHITE/ tan  +  brake pedal switch
Parking Brake dk. GREEN / WHITE  -  switch or cluster, conn. 1, pin 16
Horn Trigger dk. GREEN/ orange  +  horn or IPM, conn. 2, pin 35
Notes: The IPM (Integrated Power Module) is on the driver fender, behind the battery.
Memory Seat 1 lt. GREEN/ orange  -  driver door module in door
Notes: The memory seats are negative trigger thru resistors. The resistor values are not known at this time. Cut the wire and meter it while pressing the memory seat buttons.
Memory Seat 2 same as memory seat 1 wire  -  
Memory Seat 3 N/A  -  
posted_image
Interface Module:Category:
Immobilizer Bypass
Required:
Yes
Type:
Sentry Key
Part #: 556CW
Alternate Part1 #: 556UW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes: Standard on all models.
Interface Module:Category:
Door Lock Interface
Required:
Yes
Type:
Multiplex
Part #: 456LW
Notes:
posted_image


-------------
The Shagmaster
1999 Chevy Suburban 15" lift sittn on 22's sets 7'5"
1992 Chevy Astro Van all Bagged out Dubbed THE SUICIDER
Installing for over 18 years Looking for empolyment NOW send PM for resum




Posted By: swamprat323
Date Posted: September 28, 2006 at 3:45 PM
direct fax 1084 is in the down load section





Print Page | Close Window