hi everyone.
looking for a wiring diagram for a 02 intrepid. putting in a remote start and alarm with keyless.
thanks in advance
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|pink/black or red |+ |ignition harness |
| STARTER|yellow |+ |ignition harness |
| IGNITION|dk. blue/white |+ |ignition harness |
| SECOND IGNITION|GREEN/ red |+ |ignition harness |
| ACCESSORY|BLACK/ orange |+ |ignition harness |
| SECOND ACCESSORY|BLACK/ white |+ |ignition harness |
| POWER LOCK|WHITE/ green |*1 |back of fusebox |
| POWER UNLOCK|same wire |*1 | |
| LOCK MOTOR|orange | |BCM *2 |
| UNLOCK MOTOR|dk. blue | |BCM *2 |
| DISARM DEFEAT|pink/black | |BCM *2 |
| PARKING LIGHTS +|do not use | | |
| PARKING LIGHTS -|yellow *3 | |headlight switch |
| HEADLIGHTS|pur & pur/red or *3 |+ |fuse relay box (low only) |
| DOOR TRIGGER|yellow |- |*4 |
| TRUNK/HATCH PIN|tan/black |- |drivers kick panel |
|TRNK/HTCH RELEASE|BLACK/ white |+ |at release switch |
| FCTRY ALARM ARM|lt. GREEN/ orange |*6 |drivers kick panel |
|FCTRY ALRM DISARM|same wire | | |
| TACHOMETER|*5 | |one of the coils |
| BRAKE WIRE|WHITE/ tan |+ |at brake switch |
| HORN TRIGGER|BLACK/ red |- |steering column |
| WIPERS| | | |
| LF WINDOW UP/DN|lt. blue - white |A |at drivers door motor |
| RF WINDOW UP/DN|brn/wht - pur/wht |A |in drivers door or dkp |
| LR WINDOW UP/DN|blu/wht - RED / blu |A |in drivers door or dkp |
| RR WINDOW UP/DN|gry/blk - grn/wht |A |in drivers door or dkp |
Notes:
NOTE: Chrysler vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting. Use DEI part number 555C or 555U. *1 Locks are positive trigger through resistors. Use 2.7K (2700) ohms for lock and 620 ohms for unlock. *2 BCM is located on the left side of dash with junction block. *3 Use a 110 ohm resistor to ground (-) for parking lights and a 220 ohm resistor to ground (-) will do both headlights and parking lights. *4 In a brown connector at the rear of the fuse box. *5 This vehicle has an ignition coil for each cylinder. For tach use a tan/stripe wire at any one of the coils. *6 Arm is positive trigger thru a 1.87K ohm resistor, this will also lock the doors. Disarm is positive trigger thru a 680 ohm resistor, if use double pulse this will also unlock the doors. Must use relays.
-------------