| Print Page | Close Window |
Alarm/Remote Start Wiring, 2006+ BMW 3 SeriesPrinted From: the12volt.comForum Name: Vehicle Wiring Information & File Requests Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83976 Printed Date: May 09, 2025 at 6:55 PM Topic: Alarm/Remote Start Wiring, 2006+ BMW 3 Series Posted By: SDRandy Subject: Alarm/Remote Start Wiring, 2006+ BMW 3 Series Date Posted: October 10, 2006 at 9:34 PM I'm looking for the wiring diagrams for a 2006 or 2007 3 series BMW sedan (E90) or coupe (E92)? I have searched the database on this website as well as this forum without any success.
Any help is much appreciated! Replies: Posted By: gcorrea Date Posted: October 11, 2006 at 10:35 PM DIRECTWIRE™ WIRING INFORMATION - BMW / 3 SERIES / 2003 / Remote Start [PRINT THIS PAGE] 12volts RED / green and RED / blue + ignition harness Starter BLACK/ blue + ignition harness Second Starter Ignition green + ignition harness Second Ignition purple + ignition harness Third Ignition Accessory Second Accessory Keysense Power Lock blue/red - 54 pin plug, pin 22 at general mod Notes: The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left. Power Unlock WHITE/ black - 54 pin plug, pin 20 at general mod Notes: The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left. On some models, unlock may require a double pulse. Lock Motor white (any one of 5) 5wi 54 pin plug at general module Notes: The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left. Unlock Motor blue 5wi 54 pin plug, pin 35 at general mod Notes: The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left. Parking Lights+ Parking Lights- see notes Notes: Need to remove the light switch module from the dash and pop off the front cover. A ribbon cable which connects the switch to the module will be exposed. With the switch facing towards you, you need to interrupt the fourth wire from the left with a relay. When interrupted the parking lights will comes on. See DirectFax document 1055 for wiring information. Hazards Turn Signal(L) Turn Signal(R) Reverse Light Door Trigger RED / blue + 54 pin plug, pin 18 at general mod Notes: The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left. Dome Supervision comes on with unlock Trunk/Hatch Pin WHITE/ brown - driver kick panel Hood Pin PURPLE / green - 26 pin plug, pin 7 at general mod Notes: The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left. Trunk/Hatch Release gray/green + 54 pin plug, pin 17 at general mod Notes: The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left. Power Sliding Door Factory Alarm Arm arms with lock Factory Alarm Disarm disarms with unlock Disarm No Unlock Tachometer black ac diagnostic plug Notes: The diagnostic plug is on the passenger side of the engine compartment. If the vehicle does not have the diagnostic plug then the black wire can be found at the data link connector under the driver side dash. Wait to start Brake Wire BROWN / white + brake pedal switch Parking Brake Horn Trigger PURPLE / blue + horn relay Notes: The horn relay is above the general module. It is the green relay to the right of an orange relay. Memory Seat 1 Memory Seat 2 Memory Seat 3 Interface Module: Category: Immobilizer Bypass Required: Yes Type: EWS III Part #: 556UW Alternate Part1 #: DesignTech 20402 Alternate Part2 #: DesignTech 29402 Notes: Smart Starter Kill Relays: Not Available warning This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. ------------- gcorrea Posted By: SDRandy Date Posted: October 11, 2006 at 11:01 PM Thanks! I noticed this is for 2003-- do you expect it will be the same for later models?
Posted By: gcorrea Date Posted: October 12, 2006 at 12:19 AM my bad, this is the 05
DIRECTWIRE™ WIRING INFORMATION - BMW / 3 SERIES / 2005 / Remote Start [PRINT THIS PAGE] 12volts RED / blue (50A), RED / grn (50A) + ignition harness Starter BLACK/ blue + ignition harness Second Starter N/A Ignition green + ignition harness Second Ignition purple + ignition harness Third Ignition N/A Accessory N/A Second Accessory N/A Keysense GREEN/ red + ignition harness Power Lock yellow/red - General Module, middle plug, pin 7 Notes: Negative pulses on this wire will alternate between lock and unlock. Can also use the factory alarm arm and disarm wires. The General Module is behind the glovebox. Power Unlock same as power lock wire Lock Motor white 5wi General Module, middle plug, pin 13 Notes: The General Module is behind the glovebox. Unlock Motor blue 5wi General Module, middle plug, pin 51 Notes: The General Module is behind the glovebox. Parking Lights+ gray/purple (L), gray/yel (R) + light switch module, pins 49, 37 Notes: The light switch module is attached to the back of the headlight switch. On the wagons, these wires are in pins 30 and 29. Parking Lights- see DirectFax document 1055 Hazards BROWN / blue - sw or light switch module, pin 24 Notes: The light switch module is attached to the back of the headlight switch. Turn Signal(L) blue/green (F), blue/green (R) + light switch module, pins 50, 1 Notes: The light switch module is attached to the back of the headlight switch. Turn Signal(R) blue/brown (F), blue/brown (R) + light switch module, pins 11, 43 Notes: The light switch module is attached to the back of the headlight switch. Reverse Light blue / YELLOW + DKP or cluster, 18 pin plug, pin 7 Door Trigger see notes - General Module, middle plug Notes: The LF door is BROWN / gray / YELLOW in pin 26. The RF door is BROWN / gray / YELLOW in pin 25. The LR door is BROWN / gray in pin 24. The RR door is BROWN / black in pin 23. Use all four wires and diode isolate each. The General Module is behind the glovebox. Dome Supervision RED / blue + General Module, middle plug, pin 18 Notes: The General Module is behind the glovebox. Trunk/Hatch Pin WHITE/ brown - driver kick or light in trunk Hood Pin PURPLE / green - General Module, left plug, pin 7 Notes: The General Module is behind the glovebox. Trunk/Hatch Release gray/brown - General Module, middle plug, pin 6 Notes: The trunk release motor wire is gray/green (+) at the General Module, middle plug, pin 17. The General Module is behind the glovebox. Power Sliding Door N/A Factory Alarm Arm blue/red - General Module, middle plug, pin 22 Notes: Meter this wire while turning the key in the driver door key cylinder. This wire will also lock the doors. The General Module is behind the glovebox. Factory Alarm Disarm WHITE/ black - General Module, middle plug, pin 20 Notes: Meter this wire while turning the key in the driver door key cylinder. This wire will also unlock the doors. On some models, it may require a double pulse to unlock the doors. The General Module is behind the glovebox. Disarm No Unlock Tachometer black ac OBD socket under driver dash, pin 9 Wait to start N/A Brake Wire blue/red + brake pedal switch Notes: Meter this wire with the ignition on. Parking Brake blue/BROWN / yellow - sw or cluster, 26 pin plug, pin 23 Horn Trigger PURPLE / blue + horn relay behind glovebox Memory Seat 1 N/A Memory Seat 2 N/A Memory Seat 3 N/A Interface Module: Category: Immobilizer Bypass Required: Yes Type: EWS III Part #: 556UW Alternate Part1 #: DesignTech 20402 Alternate Part2 #: DesignTech 29402 Notes: Standard on all models. Smart Starter Kill Relays: Not Available warning This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. ------------- gcorrea Posted By: gcorrea Date Posted: October 12, 2006 at 12:20 AM i found one for the 06 but its for the uk version. hope this helps some.
------------- gcorrea Posted By: gcorrea Date Posted: October 12, 2006 at 12:22 AM here it is anyways.
DIRECTWIRE™ WIRING INFORMATION - BMW / 3 SERIES(E90) (UK) / 2006 / Remote Start [PRINT THIS PAGE] 12volts red + see note Notes: black 41way connector found at the CAS unit driverside left hand side of steering column, pin 21 Starter black + see note Notes: black 41way connector found at the CAS unit driverside left hand side of steering column, pin20 Second Starter Ignition see note Second Ignition Third Ignition Accessory Second Accessory Keysense Power Lock yellow/brown - see note Notes: black 41way connector found at the CAS unit driverside left hand side of steering column, pin 33 Power Unlock as above Lock Motor Unlock Motor Parking Lights+ Parking Lights- Hazards Turn Signal(L) blue/green x2 blue / YELLOW + see note Notes: LIGHT-51way BLACK/ grey connector top of the light control unit drivers kick pin11,12,13 RIGHT-51way BLACK/ grey connector bottom part of the light control unit drivers kick pin40,44,45 Turn Signal(R) blue/brown x2 blue / YELLOW + see note Notes: LIGHT-51way BLACK/ grey connector top of the light control unit drivers kick pin11,12,13 RIGHT-51way BLACK/ grey connector bottom part of the light control unit drivers kick pin40,44,45 Reverse Light Door Trigger RED / blue + drivers side kick light Dome Supervision Trunk/Hatch Pin WHITE/ brown - at glovebox light Hood Pin Trunk/Hatch Release Power Sliding Door Factory Alarm Arm same as lock Factory Alarm Disarm same as unlock Disarm No Unlock Tachometer Wait to start Brake Wire Parking Brake Horn Trigger Memory Seat 1 Memory Seat 2 Memory Seat 3 Interface Modules: Not Available Smart Starter Kill Relays: Not Available warning This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. ------------- gcorrea Posted By: SDRandy Date Posted: October 13, 2006 at 1:46 AM Thanks guys! Really appreciate it! :)
|
| Print Page | Close Window |