06 Accord alarm/remote start wiring

Hi, I need the wiring codes for putting in a starter/alarm for an 06 Accord, need ASAP

Thanks

-------------
Solartech Window Tinting & Electronics Inc.

12volts  white (50A)  +  ignition harness Starter  BLACK/ white  +  ignition harness Second Starter  N/A     Ignition  BLACK / YELLOW  +  ignition harness Second Ignition  N/A     Third Ignition  N/A     Accessory  BLACK/ red  +  ignition harness Second Accessory  WHITE/ red  +  ignition harness Keysense  RED / white or RED / black  -  ign harn or MICU, green plug, pin 13 Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box. Power Lock  pink/black  -  MICU, green plug, pin 25 Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box. Meter this wire while pressing the passenger door lock switch. Power Unlock  pink/blue  -  MICU, green plug, pin 9 Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box. Meter this wire while pressing the passenger door lock switch. Lock Motor  yellow/black  5wi  frt of fuse box, lt. grn 12 pin plug Unlock Motor  YELLOW /GREEN  5wi  frt of fuse box, lt. grn 12 pin plug Parking Lights+  RED / black  +  top of fuse box, large white plug Parking Lights-  RED / black  -  headlight switch in column cover Hazards  GREEN/ red  +  top of fuse box, large white plug Turn Signal(L)  RED / blue  +  top of fuse box, large white plug Turn Signal(R)  brown  +  top of fuse box, large white plug Reverse Light  green  +  driver kick, harness to rear Door Trigger  see notes  -  back of fuse box Notes: The LF door is green in a lt. green 16 pin plug, pin 15. The RF door is lt. GREEN/ red in a lt. green 14 pin plug, pin 12. The LR door is GREEN/ YELLOW in a lt. green 16 pin plug, pin 14. The RR door is GREEN / WHITE in a lt. green 14 pin plug, pin 13. Use all four wires and diode isolate each. Dome Supervision  GREEN/ red  -  back of fuse box, lt. grn 5 pin plug Trunk/Hatch Pin  blue/black  -  MICU, green plug, pin 24 Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box. Hood Pin  yellow/red to GREEN/ black  -  hood pin switch in latch Trunk/Hatch Release  YELLOW /GREEN  +  driver kick, harness to rear Power Sliding Door  N/A     Factory Alarm Arm  blue/white to WHITE/ red  -  driver door module in door Factory Alarm Disarm  BLACK/ red to white  -  driver door module in door Disarm No Unlock  see factory alarm disarm     Tachometer  blue/red or blue  ac  ECM/PCM Notes: The ECM/PCM is on the front of the transmission tunnel. The connectors are on the passenger side. On the 4 cylinder models the tach wire is in the white 31 pin connector E, pin 25. On the 6 cylinder models it is in the gray connector A, pin 23. Can also go to any ignition coil and use the wire that is NOT BLACK/ white or black. Can also go to any fuel injector and use the wire that is NOT yellow/black. Wait to start  N/A     Brake Wire  WHITE/ black  +  brake pedal switch Parking Brake  GREEN/ orange  -  top of fuse box, large white plug Horn Trigger  GREEN/ YELLOW  -  horn switch Memory Seat 1  N/A     Memory Seat 2  N/A     Memory Seat 3  N/A     Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder Part #: 556HW Alternate Part1 #: 556UW Alternate Part2 #: DesignTech 20402 Alternate Part3 #: DesignTech 29402 Notes: Standard on all models. When using the 556HW, follow the mode 1 wiring diagram. The reference wire is BROWN / yellow, data wire is RED / blue and ignition wire is BLACK / YELLOW. Smart Starter Kill Relays: Not Available

-------------
bring back the rotary phone so i dont have to press 1 to proceed in english