06 Ford F-150 Alarm/Remote Start Wiring
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86555
Printed Date: May 03, 2025 at 3:24 AM
Topic: 06 Ford F-150 Alarm/Remote Start Wiring
Posted By: je3169
Subject: 06 Ford F-150 Alarm/Remote Start Wiring
Date Posted: December 03, 2006 at 4:23 AM
Hey guys I am installing a RS in a 06 F150 and need the wiring diagram I search and found nothing and i also looked in the diagrams but only could find one for the 05 F150 is it the same any help would be great. Thanks John -------------
Replies:
Posted By: Twelvoltz
Date Posted: December 03, 2006 at 9:04 AM
DIRECTWIRE™ WIRING INFORMATION - FORD / F SERIES LIGHT DUTY / 2006 / Remote Start
[PRINT THIS PAGE]
12volts lt. GREEN/ purple (20A) + ignition harness
Starter RED / lt. blue + ignition harness
Second Starter N/A
Ignition dk. blue/lt. green + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory BLACK/ lt. green + ignition harness
Second Accessory N/A
Keysense BLACK/ pink + ignition harness
Power Lock pink / YELLOW - DKP or BCM, green plug, pin 9
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Power Unlock pink/lt. green - DKP or BCM, green plug, pin 1
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Lock Motor pink/black 5wi DKP or BCM, blue plug, pin 2
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Unlock Motor RED / orange 5wi DKP or BCM, blue plug, pin 5
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Parking Lights+ brown + switch or BCM, blue plug, pin 6
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Parking Lights- N/A
Hazards same as turn signal wires
Turn Signal(L) lt grn/wht (F), lt grn/org (R) + turn signal switch
Turn Signal(R) wht/lt blu (F), org/lt blu (R) + turn signal switch
Reverse Light BLACK/ pink + DKP, gray plug, pin 13
Door Trigger BLACK/ yel (L), BLACK/ pink (R) - DKP, gray plug, pins 22, 23
Notes: The wiring above is for vehicles without keyless entry. Vehicles with keyless entry, the door trigger wires are found at the BCM, green plug. The LF door trigger is BLACK / YELLOW in pin 4. The RF door trigger is BLACK/ pink in pin 5. The LR door trigger is BLACK/ lt. blue in pin 12. The RR door trigger is BLACK/ white in pin 13. Use all wires and diode isolate each.
The BCM (Body Control Module) is on the driver side rear cabin wall.
Dome Supervision BLACK/ lt. blue + DKP, gray plug, pin 6
Trunk/Hatch Pin N/A
Hood Pin N/A
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm N/A
Factory Alarm Disarm N/A
Disarm No Unlock N/A
Tachometer NOT RED / lt. green or red ac any ignition coil or fuel injector
Wait to start N/A
Brake Wire lt. green + brake pedal switch
Parking Brake lt. GREEN/ red - parking brake switch
Horn Trigger dk. blue - switch or BCM, blue plug, pin 12
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Memory Seat 1 BROWN / lt. green - memory seat switch on seat
Memory Seat 2 BLACK/ orange - memory seat switch on seat
Memory Seat 3 N/A -
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
SecuriLock
Part #: 1100F
Alternate Part1 #: 1100X
Alternate Part2 #: 556SW
Alternate Part3 #: 556UW
Alternate Part4 #: DesignTech 20402
Alternate Part5 #: DesignTech 29402
Notes: Standard on all models. When using the 1100X, a software change to 1100FM is needed.
Smart Starter Kill Relays: Relay Type:
Starter Relay Location:
Underdash, Passenger side fusebox, #1
Part #: 6401A
warning
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
Posted By: je3169
Date Posted: December 03, 2006 at 7:33 PM
Thanks
|