2007 Dodge Ram 2500 Alarm/RS Wiring?
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=89030
Printed Date: May 15, 2025 at 9:07 PM
Topic: 2007 Dodge Ram 2500 Alarm/RS Wiring?
Posted By: start25
Subject: 2007 Dodge Ram 2500 Alarm/RS Wiring?
Date Posted: January 15, 2007 at 11:01 PM
Does anybody have wiring diagram for 2007 Dodge Ram 2500? I'm planning to install alarm/remote start/keyless. Also...anything tips?
Replies:
Posted By: KarTuneMan
Date Posted: January 16, 2007 at 7:48 AM
Posted By: Hymer
Date Posted: January 16, 2007 at 8:50 AM
A tip... hope ya have plenty of asprin! Get the XK532 from bypasskits CHDL7 2.4 firmware in it, make sure you have both keys.. and get a GOOD remote starter.. They are not a bad install, just lots of little glitches when ya first fire them up if you don't do things correctly...
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Posted By: start25
Date Posted: January 16, 2007 at 10:47 AM
Cant find wiring diagram anywere.... Is it same as 2006 Ram?
Posted By: KarTuneMan
Date Posted: January 16, 2007 at 11:40 AM
According to the astrochart they are the same.
-------------
Posted By: Velocity Motors
Date Posted: January 16, 2007 at 11:05 PM
It is the same. It will have the new resistor based ACC & 2nd starter wire. Grab 12 volts at the battery and not at the BCM connector or at the low voltage wire at the ignition switch.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: azn_fcuk
Date Posted: January 16, 2007 at 11:43 PM
I have the exact same install tommorow. No glowplugs, there is an AirHeater relay relay/fuse box in the engine bay that apparantly you have to use to trip the diesel mode, its pos polarity. Can anyone verify this for me.
Posted By: Velocity Motors
Date Posted: January 17, 2007 at 8:12 AM
Just use a delay timer on this truck and set for 5 seconds. Use the cam position sensor wire for tach or tach wire at the PCM on the drivers side of engine bay just above the front axles.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: azn_fcuk
Date Posted: January 17, 2007 at 9:08 AM
Is there a way to delay it with out using an aftermarket module? i.e. gwr wire connected to the glowplug wire?
|