Looking for wiring info for a 2003 Land Rover Freelander. Specifically for a remote starter
Thank you,
John
pulltotheright
12volts brown (60A), BROWN / red (60A) + ignition harness
Starter WHITE/ red + ignition harness
Ignition green + ignition harness
Second Ignition BROWN / white + ignition harness
Accessory gray/blue + ignition harness
Second Accessory PURPLE / gray + ignition harness
Power Lock BLACK/ brown - CCU, 26 pin plug, pin 20
Power Unlock BLACK/ pink - CCU, 26 pin plug, pin 8
Lock Motor pink 5wi CCU, 10 pin plug, pin 4
Unlock Motor orange 5wi CCU, 10 pin plug, pin 7
Parking Lights+ red or RED / white + headlight switch
Hazards same as turn signal wires
Turn Signal(L) GREEN/ red + turn signal switch
Turn Signal(R) GREEN / WHITE + turn signal switch
Reverse Light GREEN/ brown + CCU, 26 pin plug, pin 4
Door Trigger pur/gray (D), pur/wht (P) - CCU, 26 pin plug, pins 24 and 21
Notes: Use both wires and diode isolate each..
Dome Supervision use door trigger wire
Trunk/Hatch Pin BLACK/ orange - CCU, 26 pin plug, pin 23
Hood Pin RED / purple - CCU, 26 pin plug, pin 22
Trunk/Hatch Release ORANGE / brown - CCU, 26 pin plug, pin 18 .
Factory Alarm Arm BLACK/ pink - CCU, 26 pin plug, pin 19
Factory Alarm Disarm BLACK/ red - CCU, 26 pin plug, pin 7
Tachometer NOT BROWN / pink or black ac any ignition coil
Brake Wire GREEN/ purple or GREEN/ pink + brake pedal switch
Parking Brake BLACK/ white - parking brake switch
Horn Trigger purple / YELLOW - CCU, 10 pin plug, pin 5
Notes: The CCU (Central Control Unit) is attached to the back of the fuse box under the driver side dash.
I
Immobilizer Bypass Required
Type:Transponder
Hope that helped..remember to verify all wires with a DMM before connecting as no one is responsible for the installation but you and mistakes/changes happen.
-------------