Print Page | Close Window

mazda 6

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=8941
Printed Date: April 19, 2024 at 9:58 PM


Topic: mazda 6

Posted By: rick1234
Subject: mazda 6
Date Posted: February 02, 2003 at 9:50 AM

does anyone have a diagram for 2003 mazda 6?



Replies:

Posted By: jayts95
Date Posted: February 02, 2003 at 10:49 AM

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |
|              12V|black (x2)          |+  |ignition harness            |
|          STARTER|green               |+  |ignition harness            |
|         IGNITION|BLACK/ white         |+  |ignition harness            |
|  SECOND IGNITION|BLACK/ red           |+  |ignition harness            |
|        ACCESSORY|blue                |+  |ignition harness            |
|       POWER LOCK|BROWN / yellow        |-  |*2                          |
|     POWER UNLOCK|white & brn/wht *3  |-  |*2                          |
|       LOCK MOTOR|green               |   |drivers kick panel          |
|     UNLOCK MOTOR|pink                |   |drivers kick panel          |
|    DISARM DEFEAT|red                 |   |passengers kick panel       |
| PARKING LIGHTS +|WHITE/ red           |   |green plug at fuse box      |
| PARKING LIGHTS -|lt GREEN/ red        |   |headlight switch            |
|       HEADLIGHTS|yellow              |-  |headlight switch            |
|     DOOR TRIGGER|RED / white           |-  |green plug at fuse box      |
| DOME SUPERVISION|use door trigger    |   |                            |
|  TRUNK/HATCH PIN|WHITE/ black         |-  |at light in trunk *5        |
|         HOOD PIN|                    |   |                            |
|TRNK/HTCH RELEASE|orange              |-  |*2                          |
|  FCTRY ALARM ARM|                    |   |                            |
|FCTRY ALRM DISARM|                    |   |                            |
| DISARM NO UNLOCK|*4                  |   |                            |
|       TACHOMETER|*1                  |   |ignition coil               |
|      SPEED SENSE|gray/blue           |   |instrument cluster or ECM *6|
|       BRAKE WIRE|purple              |+  |brake pedal switch          |
|     HORN TRIGGER|grn/red or grn/org  |-  |steering column             |
|           WIPERS|blu/wht(L),blu/red(H|+  |steering column             |
|  LF WINDOW UP/DN|red - RED / blu       |A  |drivers window switch       |
|  RF WINDOW UP/DN|grn/wht - RED / blk   |A  |drivers switch or kick panel|
|  LR WINDOW UP/DN|blu/wht - blu/blk   |A  |drivers switch or kick panel|
|  RR WINDOW UP/DN|grn/yel - wht/red   |A  |drivers switch or kick panel|

Notes:
NOTE:  This vehicle has an immobilizer system that needs to be bypassed when adding remote start. See direct fax document #1061.  *1 Use red or green for the 4 cylinder and white for the 6 cylinder.  *2 Found at two tan modules near the hood release.  *3 The white wire will unlock the drivers door only, and the BROWN / white will unlock the other doors.  use both wires and diode isolate each.  *4  To disarm with out unlocking, send a positive trigger to the blue / YELLOW key sense wire.  The key sense wire is located at the steering column.  *5 Can also find in drivers kick panel in the harness from the rear if the vehicle has a factory alarm.  *6 The ECM is under the center console. The VSS wire is in pin 58.



-------------



Posted By: draasch
Date Posted: February 07, 2003 at 10:18 PM

Has anyone confirmed the wiring info on here for the 2003 mazda 6??

Im doing an install this weekend on one.

any info would be great.

thks,

david




Posted By: Velocity Motors
Date Posted: February 10, 2003 at 10:37 AM
The above information is not correct as far as I'm concerned. The information listed is for a 2002 Mazda 626. The Mazda 6 is still too new of a vehicle and I have not seen anyone post a correct list of wiring for this vehicle. What you will have to do is use your DMM and test all wires for the proper characteristics and use your installer common sense with the door locks, door trigger, tach & other wires. Good luck and if you get this going, please post your findings for other installer's.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: draasch
Date Posted: February 10, 2003 at 11:07 AM

thks jeff,

i kind figured i'd have to do that.

ill keep everyone updated.

david


Print Page | Close Window