for this
+12 Volts | White | Ignition Harness | + | |
Ignition | BLACK / YELLOW | Ignition Harness | + | |
Accessory | BLACK/ Red | Ignition Harness | + | |
Starter | BLACK/ white | Ignition Harness | + | |
Tachometer | Blue | **See Notes | AC | |
Parking Lights | RED / Black | Driver's kick panel | + | |
Brakeswitch | WHITE/ Black | At Brake Switch Or Driver's Kick Panel | + | |
Clutch Bypass | Light Green | At switch | - | |
Parking Brake | GREEN/ Orange | at fuse box | - | |
Hoodpin | GREEN/ Black | Hood Latch | - | |
Lock | Pink/Black | Driver's kick panel | - | |
Unlock | Pink/Blue | Driver's kick panel | - | |
Trunk Release | YELLOW /GREEN | Driver's kick panel | Reversal polarity | |
Arm | WHITE/ Red | Inside Driver's Door | - | |
Disarm | White | Inside Driver's Door | - | |
Doorpin | See Notes*** | Driver's kick panel | - | |
Trunk Pin | Blue/Black | Driver's kick panel | - |
* Vehicle is equipped with a Transponder anti-theft system and an OEM alarm. ** Tach: Drivers side of engine in harness near firewall. see photo for exact location. *** Driver's Doorpin: Dk.Green (-) Rear Driver's Doorpin: GREEN/ Yellow (-) Passenger Doorpin: Lt.GREEN/ Red (-) Rear Passenger Doorpin: GREEN/ White (-) **** Manual Transmission: Use injector for Tach, if Ready Mode problems occur. ***** A Data Module is available for this vehicle.
ok thanks, now a few ?'s I am hooking up the valet 561r to the stock key pad and will be using the negative off the pink black to activate the remote start. But my other question is relaying to allow use of the lock twice since the car once started can not use the pad. also what all needs to be hooked up since I am just adding the remote start not using the door locks etc. also I am running the 556 h I think thats the correct number, it is the one without the key.