Print Page | Close Window

2000 mazda 626 v6 factory alarm

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91139
Printed Date: May 07, 2024 at 5:53 AM


Topic: 2000 mazda 626 v6 factory alarm

Posted By: negrosourous
Subject: 2000 mazda 626 v6 factory alarm
Date Posted: February 28, 2007 at 9:04 PM

I recently installed a remote start in a mazda 626 v6  and i could not intergrade the factory alarm with the after market remote start the disarm wire had no effect when i put a possitive signal to it if ,anyone knows of an other way i would appreciate it

-------------
jv



Replies:

Posted By: master5
Date Posted: March 01, 2007 at 6:43 PM

To disarm without unlocking, send a positive trigger to the blue / YELLOW key sense wire. The key sense wire is located at the steering column. If this is the way you already attempted it you either have a poor connection...the wrong blue / YELLOW (the keysense wire you should be able to follow it right to the cylinder) or you are not sending a positive (check with a DMM).

Hope I was of some help..good luck.



-------------


Print Page | Close Window