2002 Yukon Denali Alarm/Remote Start Wiring

wiring for remote star and alarm

DEI lists:


DIRECTWIRE™ WIRING INFORMATION - GMC / YUKON / 2002 / Remote Start

[PRINT THIS PAGE]

12volts      red       +       ignition harness
Starter      yellow       +       ignition harness
Second Starter      N/A            
Ignition      pink       +       ignition harness
Second Ignition      white       +       ignition harness
Notes: To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system.
Third Ignition      N/A            
Accessory      orange       +       ignition harness
Second Accessory      brown       +       ignition harness
Keysense      lt. green       -       ignition harness
Power Lock      lt. blue       +       pin A4, brown plug at BCM
Notes: The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Power Unlock      white       +       pin A3, brown plug at BCM
Notes: The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Lock Motor      gray       5wi      driver kick, door harness
Unlock Motor      tan       5wi      driver kick, door harness
Parking Lights+      brown       +       pin B6, lt. blue plug at BCM
Notes: The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Parking Lights-      white       -       pin A5, lt. blue plug at BCM
Notes: The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Hazards      same as turn signals            
Turn Signal(L)      lt. blue       +       steering column
Turn Signal(R)      dk. blue       +       steering column
Reverse Light      lt. green       +       inside rear view mirror
Door Trigger            -       BCM
Notes: Use tan for the driver door located in pin B4 of the purple plug, and the passenger doors are a blue/white in pin B11 of the lt. blue plug. Use both wires and diode isolate each.

The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Dome Supervision      use door trigger            
Trunk/Hatch Pin      pink/black       -       pin B10, lt. blue plug at BCM
Notes: The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Hood Pin      N/A            
Trunk/Hatch Release      N/A            
Power Sliding Door      N/A            
Factory Alarm Arm      arms on lock            
Factory Alarm Disarm      lt. green       -       pin B3, purple plug at BCM
Notes: The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Disarm No Unlock      see factory alarm disarm            
Tachometer      white       ac       ECM
Notes: The ECM (Engine Control Module) is located near the battery, down low, between the fender and the fan under the black plastic cover. On the 4.3L, the tach wire is at pin 20 in the connector labeled red. On the 4.8L, 5.3L, and 6.0L, the tach wire is located at pin 10 in the red connector.
Wait to start      dk. blue       -       instrument cluster
Brake Wire      white       +       brake pedal switch
Parking Brake      GREEN / WHITE       -       parking brake switch
Horn Trigger      black       -       pin A9, brown plug at BCM
Notes: The BCM (Body Control Module) is located behind the driver side of the dash. The plugs face towards the rear of the vehicle.
Memory Seat 1      white       +       memory mod under dr seat
Memory Seat 2      purple       +       memory mod under dr seat
Memory Seat 3      N/A       +      
Interface Module:      Category:
Immobilizer Bypass      Required:
Yes      Type:
Passlock II
Part #: 1100F
Alternate Part1 #: 1100X
Alternate Part2 #: 556LW
Alternate Part3 #: 555LW
Alternate Part4 #: DesignTech 20402
Alternate Part5 #: DesignTech 29402
Notes: When using the 1100F or 1100X, a software change to 1100GM is needed.
Interface Module:      Category:
Door Lock Interface      Required:
No      Type:
N/A
Part #: N/A
Notes:
Interface Module:      Category:
Combo Interface      Required:
Yes      Type:
Data Bus
Part #: 1700G
Alternate Part1 #: 457GW
Notes: Can use the 1700G or 457GW to bypass the Passlock II, but it will not control the door locks on this model year.
Smart Starter Kill Relays: Not Available


warning      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.




-------------
Installer, IT support, and FFL. I need less hobbies.