Print Page | Close Window

alarm wiring diagram

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=92373
Printed Date: May 08, 2025 at 5:09 PM


Topic: alarm wiring diagram

Posted By: clock97
Subject: alarm wiring diagram
Date Posted: April 01, 2007 at 8:02 AM

i need a wiring diagram for a 2000 chevy 2500 full-size cargo van. thanks



Replies:

Posted By: fkelsey
Date Posted: April 01, 2007 at 10:54 AM
12volts red or RED / white    +   ignition harness
Starter yellow    +   ignition harness
Second Starter          
Ignition pink    +   ignition harness
Second Ignition pink/white or white    +   ignition harness
Third Ignition          
Accessory orange    +   ignition harness
Second Accessory          
Keysense          
Power Lock lt. blue    +   drivers door harness
Power Unlock white    +   drivers door harness
Lock Motor gray      drivers kick panel
Unlock Motor tan      drivers kick panel
Parking Lights+ brown      light switch
Parking Lights-          
Hazards          
Turn Signal(L)          
Turn Signal(R)          
Reverse Light          
Door Trigger purple    -   drivers door harness
Dome Supervision          
Trunk/Hatch Pin ORANGE / black    -   at light in rear cargo area
Hood Pin          
Trunk/Hatch Release          
Power Sliding Door          
Factory Alarm Arm          
Factory Alarm Disarm          
Disarm No Unlock          
Tachometer white      VCM
Notes: The VCM is located under the hood on the drivers inner fender well. The white wire is located in a black plug labeled white.

Diesel wait to start wire is dk. blue (-) located at the instrument cluster see direct fax document #1090.
Wait to start          
Brake Wire white    +   stop light switch
Parking Brake          
Horn Trigger black    -   above ignition harness
Memory Seat 1          
Memory Seat 2          
Memory Seat 3          
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Passlock II
Part #: 1100F
Alternate Part1 #: 1100X
Alternate Part2 #: 556LW
Alternate Part3 #: 555LW
Alternate Part4 #: DesignTech 20402
Alternate Part5 #: DesignTech 29402
Notes: When using the 1100F or 1100X, a software change to 1100GM is needed.
Interface Module: Category:
Door Lock Interface Required:
No Type:
N/A
Part #: N/A
Notes:
Interface Module: Category:
Combo Interface Required:
Yes Type:
Data Bus
Part #: 1700G
Alternate Part1 #: 457GW



Posted By: clock97
Date Posted: April 01, 2007 at 11:27 AM
thank you, thank you, thank you posted_image



Posted By: fkelsey
Date Posted: April 01, 2007 at 2:12 PM
No problem bro just let me know if you need anything else.


Print Page | Close Window