2007 trailblazer alarm wiring
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=93243
Printed Date: May 12, 2024 at 1:33 AM
Topic: 2007 trailblazer alarm wiring
Posted By: israelorta
Subject: 2007 trailblazer alarm wiring
Date Posted: April 22, 2007 at 10:37 PM
does anyone have the alarm wiring for an 07 trailblazer? if not would it be the same as a 2005?
-------------
israelorta
Replies:
Posted By: wire4veins
Date Posted: May 03, 2007 at 11:18 PM
12volts red (40A), RED / white (40A) + ignition harness
Starter yellow + ignition harness
Notes: Starter wire may not be required for remote start. On some models, when the vehicle sees that the ignition wire has voltage and the accessory wire lose voltage, it automatically cranks the starter.
Ignition pink + ignition harness
Power Lock use Directed interface module
Notes: If interface module is not available, refer to DirectFax document 1053.
Power Unlock see power lock
Lock Motor gray 5wi driver door module in door
Unlock Motor tan 5wi driver door module in door
Disarm Defeat tan 5wi fuse box under left rear seat
Parking Lights+ brown + fuse box under left rear seat
Parking Lights- gray/black - switch or BCM, tan plug, pin E5
Notes: The BCM is attached to the fuse box under the left rear seat.
Hazards white - hazard switch
Turn Signal(L) dk. green + turn signal switch
Turn Signal(R) lt. green + turn signal switch
Door Trigger use dome supervision wire - see notes
Notes: To avoid dome light delay, use the separate door trigger wires. The LF door is gray/black (-) at the driver door module in the door. The RF door is BLACK/ white (-) at the passenger door module in the door. The LR door is lt. blue/black (-), and the RR door is lt. GREEN/ black (-). The rear door trigger wires are at the fuse box under the left rear seat. Use all four wires and diode isolate each.
Dome Supervision gray/black + fuse box under left rear seat
Trunk/Hatch Pin use dome supervision wire
Notes: To avoid dome light delay, use the separate trigger wires at the liftgate module in the liftgate. The liftgate is pink/black (-), and the glass hatch is purple (-). Use both wires and diode isolate each.
Hood Pin pink/black (export only) - switch or BCM, tan plug, pin E6
Notes: The BCM is attached to the fuse box under the left rear seat.
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm arms with interface module
Factory Alarm Disarm disarms with interface module
Disarm No Unlock lt. grn (if no interface mod) - driver door module in door
Tachometer white ac cluster or PCM/ECM, blue plug
Notes: 4.2L: The PCM is attached to the driver side of the engine. Tach is in pin 31.
5.3L and 6.0L: The ECM is near the lower front driver side of the engine. Tach is in pin 48.
Can also go to any fuel injector and use the wire that is NOT pink.
Horn Trigger BLACK / YELLOW to black - switch or BCM, tan plug, pin E12
Notes: The BCM is attached to the fuse box under the left rear seat.
Memory Seat 1 white + driver door module in door
Memory Seat 2 purple + driver door module in door
Memory Seat 3 N/A +
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Passlock II
-------------
wire4veins
"D"
Precision Autosound - Owner
MECP Master Installer
|