2008 ford escape hybrid

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=94049
Printed Date: May 21, 2024 at 1:57 PM

Topic: 2008 ford escape hybrid

Posted By: madmx
Subject: 2008 ford escape hybrid
Date Posted: May 18, 2007 at 5:48 PM

Looking for wiring diagram for a remote start/ alarm connections..

Thanks in Advanced.

Replies:

Posted By: mikvot
Date Posted: May 18, 2007 at 8:13 PM

Here you go. I've done a few hybrid alarms and they are the same as the regular escape.And of course, you need to test all of your wires with a DMM. https://www.the12volt.com/installbay/forum_posts.asp~TID~93093~PN~1

-------------

Posted By: madmx
Date Posted: May 19, 2007 at 12:54 PM

Mikvot,

I see that the diagram shows both a "unlock/lock (-)" and "lock/unlock motor(+)". Which one do I use?

-Patrick

Posted By: madmx
Date Posted: May 19, 2007 at 1:13 PM

also, the wiring instructions for the alarm/starter (prostar gold) show a "Heater/Air-conditioner Output(+). It says to connect to the blow motor wire. Would that just be connected to the Accessory wire? Or is it not needed?

Posted By: mikvot
Date Posted: May 19, 2007 at 7:38 PM

Use the (-) wires to lock and unlock the vehicle. This is, assuming your systems door lock outputs are (-). Don't worry about the (+) lock/unlock wires i listed...they are only used if you are adding a system that works with the factory keyfobs. The wire labeled heater/ac would go to the acc. wire of the vehicle. Let me know if you need anything else...i'll help any way i can!

-------------

Posted By: madmx
Date Posted: May 19, 2007 at 9:45 PM

thanks mikvot. still waiting for the alarm to be shipped so I havent started yet. just trying to get all the info I need before I dig in.

How about window rollup modules? I tried to install on my 2006 Ford FiveHundred but was not successful because there is some kind of circuity board the connects to the window motor contacts and I was not able to connect directly to the motors. Do you know if the 2008 escape has the same setup?

Print Page | Close Window