Print Page | Close Window

2007 dodge durango, ignition wiring

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=94693
Printed Date: May 17, 2024 at 5:15 PM


Topic: 2007 dodge durango, ignition wiring

Posted By: siren-installer
Subject: 2007 dodge durango, ignition wiring
Date Posted: June 11, 2007 at 2:05 PM

Does anyone know if the ign wire harness for a 07 dodge durango has change from the 06 model?



Replies:

Posted By: rudydapimp
Date Posted: June 12, 2007 at 8:57 AM
from diagrams on directechs, not even close to being the same. Might as well be a different car.




Posted By: siren-installer
Date Posted: June 12, 2007 at 7:46 PM

Thanks, every web page only shows 2006 and nothing newer. So Directtechs diagram is showing a 07?





Posted By: rudydapimp
Date Posted: June 12, 2007 at 11:16 PM
yes.
Info on the 2007
12volts      lt. blue/red (10A)       +       ignition harness
Starter      gry/yel (not for remote start)      +       driver fender, 16 pin plug, pin 1
Second Starter      PURPLE / brown       -       ignition harness
Notes: Starter is negative trigger thru a 180 ohm resistor. Refer to DirectFax document 1084 for wiring information.
Ignition      pink/gray       +       ignition harness
Second Ignition      N/A            
Third Ignition      N/A            
Accessory      same as second starter wire            
Notes: Accessory is negative trigger thru a 560 ohm resistor. Refer to DirectFax document 1084 for wiring information.
Second Accessory      N/A            
Keysense      same as second starter wire            
Notes: Key sense is negative trigger thru a 8500 ohm resistor.
Power Lock      lt. blue/orange       -       switch or DDM, 20 pin plug, pin 16
Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays.

The DDM (Driver Door Module) is in the driver door.
Power Unlock      same as power lock wire            
Lock Motor      lt. green       5wi      DKP or cluster, gry 26P plug, pin 15
Unlock Motor      tan/lt. green or dk. GREEN/ red      5wi      DKP or cluster, gry 26P plug, pin 12
Parking Lights+      pink/red (L), WHITE/ orange (R)      +       fuse box, black plug, pins 6 and 5
Notes: The FB (Fuse Box) is in the driver kick panel.
Parking Lights-      pink/red       -       sw or cluster, gry 16P plug, pin 5
Notes: Parking lights are negative trigger thru a 1130 ohm resistor. MUST use a relay.
Hazards      WHITE/ dk. blue       -       sw or cluster, gry 16P plug, pin 8
Notes: Hazards are negative trigger thru a 120 ohm resistor. MUST use a relay.
Turn Signal(L)      wht/lt. grn(F), wht/dk. grn(R)      +       light (F); FB, blk plug, pin 22 (R)
Notes: The FB (Fuse Box) is in the driver kick panel.
Turn Signal(R)      WHITE/ tan (F), PURPLE / gray (R)      +       light (F); FB, blk plug, pin 21 (R)
Notes: The FB (Fuse Box) is in the driver kick panel.
Reverse Light      WHITE/ red       +       fuse box, black plug, pin 18
Notes: The FB (Fuse Box) is in the driver kick panel.
Door Trigger      see notes       -       see notes
Notes: The LF door is purple at the DDM, 20 pin plug, pin 5. The RF door is PURPLE / white at the PDM, 20 pin plug, pin 5. The LR door is PURPLE / gray in the driver kick or at the cluster, gray 26 pin plug, pin 8. The RR door is purple / YELLOW in the driver kick or at the cluster, white plug, pin 22. Use all four wires and diode isolate each.

The DDM (Driver Door Module) is in the driver door.

The PDM (Passenger Door Module) is in the passenger door.
Dome Supervision      yellow/orange       +       DKP or cluster, wht plug, pin 11
Trunk/Hatch Pin      PURPLE / orange       -       DKP or cluster, gry 26P plug, pin 4
Hood Pin      PURPLE / lt. blue       -       hood pin switch
Trunk/Hatch Release      PURPLE / tan (power liftgate)       -       switch or PLM, 22 pin plug, pin 14
Notes: The power liftgate open/close is negative trigger thru a 4700 ohm resistor. MUST use a relay.

The PLM (Power Liftgate Module) is in the driver side rear quarter panel.
Power Sliding Door      N/A            
Factory Alarm Arm      arms on lock with door open            
Factory Alarm Disarm      factory remote only            
Disarm No Unlock      with ign, keysense, Sentry Key           
Tachometer      NOT red       ac       any ignition coil or fuel injector
Wait to start      N/A            
Brake Wire      WHITE/ tan       +       switch or fuse box, blk plug, pin 19
Notes: The FB (Fuse Box) is in the driver kick panel.
Parking Brake      dk. GREEN / WHITE       -       sw or cluster, gry 26P plug, pin 3
Horn Trigger      dk. GREEN/ purple       -       sw or cluster, gry 26P plug, pin 10
Memory Seat 1      lt. GREEN/ dk. blue       -       switch or DDM, 12 pin plug, pin 5
Notes: Memory seat 1 is negative trigger thru a 7000 ohm resistor. Memory seat 2 is negative trigger thru a 2000 ohm resistor. MUST use relays.

The DDM (Driver Door Module) is in the driver door.
Memory Seat 2      same as memory seat 1 wire       -      
Memory Seat 3      N/A       -      
Interface Module:      Category:
Immobilizer Bypass      Required:
Yes      Type:
Sentry Key
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Standard on all models.
Interface Module:      Category:
Door Lock Interface      Required:
No      Type:
Multiplex
Part #: 456LW
Notes:Info on the 2007Info on the 2007





Print Page | Close Window