2007 Sebring Sedan, Remote Start/Alarm Wiring
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96619
Printed Date: May 12, 2025 at 10:40 AM
Topic: 2007 Sebring Sedan, Remote Start/Alarm Wiring
Posted By: 1000toni
Subject: 2007 Sebring Sedan, Remote Start/Alarm Wiring
Date Posted: August 23, 2007 at 5:15 PM
Anyone have the wiring color diagrams for a 2007 sebring , need to install a remote starter & alarm.
Thank you!
Replies:
Posted By: ceasar326
Date Posted: August 23, 2007 at 5:37 PM
CHRYSLER / SEBRING SEDAN / 2007 / Remote Start12volt | RED / tan (10A) | + | ignition harness | Starter | yel/pur (not for remote start) | + | driver fender | Notes: On the 4 cylinder models, it is in a 20 pin plug, pin 12.
On the 6 cylinder models, it is in a 14 pin plug, pin 6.
Also found at the TIPM, lt. gray 8 pin plug, pin 8.
The TIPM (Totally Integrated Power Module) is under the hood on the driver fender. | Second Starter | PURPLE / brown | - | ignition harness | Notes: Starter is negative trigger thru a 180 ohm resistor. See DirectFax document 1084 for wiring information. | Ignition | pink | + | ignition harness | Second Ignition | N/A | | | Third Ignition | N/A | | | Accessory | same as second starter wire | | | Notes: Accessory is negative trigger thru a 610 ohm resistor. See DirectFax document 1084 for wiring information. | Second Accessory | N/A | | | Keysense | same as second starter wire | | | Notes: Key sense is negative trigger thru a 8500 ohm resistor. | Power Lock | lt. grn/pur or lt. grn/dk. grn | - | DKP or cluster, brown plug, pin 18 | Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays. | Power Unlock | same as power lock wire | | | Lock Motor | tan/dk. blue | 5wi | DKP or cluster, bk 10 pin plg, pin 9 | Unlock Motor | tan/dk. green | 5wi | DKP or cluster, bk 10 pin plg, pin 5 | Parking Lights+ | WHITE/ purple | + | driver kick, harness to rear | Parking Lights- | (LIN data bus) | | | Hazards | (LIN data bus) | | | Turn Signal(L) | wht/lt. grn(F), wht/dk. grn(R) | + | light (F); dr kick, harn to rear (R) | Turn Signal(R) | WHITE/ tan (F), WHITE/ yel (R) | + | light (F); dr kick, harn to rear (R) | Reverse Light | WHITE/ lt. green | + | driver kick, harness to rear | Door Trigger | see notes | - | each kick or cluster, brown plug | Notes: The LF door is purple in pin 3. The RF door is PURPLE / white in pin 11. The LR door is PURPLE / gray in pin 5. The RR door is purple / YELLOW in pin 6. Use all four wires and diode isolate each. | Dome Supervision | yellow/white | + | DKP or cluster, brown plug, pin 4 | Notes: Also found in the passenger kick or in the passenger side A pillar. | Trunk/Hatch Pin | PURPLE / orange | - | DKP or cluster, brown plug, pin 13 | Hood Pin | PURPLE / lt. blue | - | hood pin switch under hood | Trunk/Hatch Release | lt. GREEN / WHITE | - | sw or cluster, bk 20 pin plg, pin 13 | Notes: The trunk release motor wire is tan / YELLOW (+) in the driver kick or at the cluster, black 10 pin plug, pin 4. | Power Sliding Door | N/A | | | Factory Alarm Arm | arms on lock with door open | | | Factory Alarm Disarm | factory remote only | | | Disarm No Unlock | with ign, keysense, Sentry Key | | | Tachometer | NOT BROWN / dk. blu or BROWN / yel | ac | any ignition coil or fuel injector | Wait to start | N/A | | | Brake Wire | dk. GREEN / WHITE | + | switch or cluster, brown plug, pin 8 | Parking Brake | dk. GREEN / WHITE | - | switch or cluster, brown plug, pin 7 | Horn Trigger | dk. GREEN/ purple | - | sw or cluster, bk 20 pin plg, pin 10 | Memory Seat 1 | N/A | | | Memory Seat 2 | N/A | | | Memory Seat 3 | N/A | | |
Interface Module: | Category: Immobilizer Bypass | Required: Yes | Type: Sentry Key | Part #: PKU-CH2X | Alternate Part1 #: 556CW | Alternate Part2 #: 556UW | Alternate Part3 #: DesignTech 20402 | Alternate Part4 #: DesignTech 29402 | Notes: Standard on all models. | Interface Module: | Category: Door Lock Interface | Required: No | Type: Data Bus | Part #: XK03 | Alternate Part1 #: 456LW | Notes: | Interface Module: | Category: Combo Interface | Required: No | Type: Data Bus | Part #: XK532 | Alternate Part1 #: IOM-Chrysler-7 | Notes: When using the combo module it is not necessary to use doc 1084. That part takes care of 2nd starter and accessory, locks, and bypass. |
|
Posted By: 1000toni
Date Posted: August 24, 2007 at 12:59 PM
ok tanks.
|