Print Page | Close Window

xk05 bypass

Printed From: the12volt.com
Forum Name: Mobile Video, GPS, and Navigation
Forum Discription: Mobile Video Head Units, DVD Players, LCD and TFT Monitors, Navigation, GPS, PS2, PS3, XBox, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108262
Printed Date: May 15, 2025 at 12:26 AM


Topic: xk05 bypass

Posted By: x-fire
Subject: xk05 bypass
Date Posted: October 20, 2008 at 8:51 AM

I'm installing a Code Alarm CA530 on a 2008 Honda Civic EX sedat A/T using a XK05 bypass module. 

The remote start works fine WITH the key in the ignition, but I'm having problems with the bypass. 

During bypass programming (1st time the key is turned to ignition) the LED  quickly flashes on once, then turns off.  The key is removed from the ignition.  The car cranks via remote start, but won't fire.  If the key is placed in the ignition again and turned on, the LED stays on continuously and the car still won't start with via remote.

Four wire hook up.  Red-constant power, Black-ground, Brown-blue /black trace on CA530 and Violet to light green on ignition (3rd in 7 pin connector). This is the second bypass I've tried.  Both gave the exact same results. 

Thanks for your help.




Replies:

Posted By: x-fire
Date Posted: October 20, 2008 at 8:54 AM

UPDATE: I have the bypass grounded to a dash screw along with the remote start.  Wonder if that could be the problem?




Posted By: megaman
Date Posted: October 20, 2008 at 9:02 AM

In the words of the Directechs phone support:

Check your ground.




Posted By: extreme1
Date Posted: October 22, 2008 at 8:16 PM
did you reflash the bypass to PKH4 firmware?

-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta


Print Page | Close Window