kenwood kvt 715 password bypass?

I have a customer that just bought his 2004 Tundra from the dealership, and it has the in-dash already installed. It has the password displayed right now. Does anyone know the password bypass procedure/code? I have got several conflicting responses from local installers, and thought you guys could help.

-------------
DO IT MYSELF INC.

Try this homie...

Kenwood Security Code Over Ride

Must use a remote with Letters and a Numbered key pad All Excelon CD receivers have the correct remote

Head units with a Rotary Volume control Knob:

1. Press and hold the Auto button.

2. While holding the Auto button, push and hold the Track Up button. The “_ _ _ _” will disappear after about 5 sec.

3. Enter KCAR using the <"Arial, sans-serif">remote control from a higher end CD Receiver or any Excelon CD Receiver.

Enter "KCAR” with the remote controller as described below.

“K”: Press TRACK UP key (>>|) after pressing 5 key twice.

“C”: Press TRACK UP key (>>|) after pressing 2 key once.

“A”: Press TRACK UP key (>>|) after pressing 2 key three times.

“R”: Press TRACK UP key (>>|) after pressing 7 key twice.

* If you commit a mistake in the code entry, the unit enters the

code request mode again.

4. Press the Track Advance button on the remote to enter the override code.

5. The unit will enter the All Off or Standby mode if done properly.

Video Unlock:

1. Use a remote from a higher end CD Receiver or any Excelon CD Receiver. Some Video remotes will work, switch on remote must be set to AUD.

2. Press 55222277 on the remote. There will be NO visual verification when entering the override code.

Head units with a Up / Down Volume control buttons:

1. Press and hold the Volume Up button.

2. While holding the Volume Up button, push and hold the Disp button. The “_ _ _ _” will disappear after about 5 sec.

3. Enter KCAR using the <"Arial, sans-serif">remote control from a higher end CD Receiver or any Excelon CD Receiver.

Enter "KCAR” with the remote controller as described below.

“K”: Press TRACK UP key (>>|) after pressing 5 key twice.

“C”: Press TRACK UP key (>>|) after pressing 2 key once.

“A”: Press TRACK UP key (>>|) after pressing 2 key three times.

“R”: Press TRACK UP key (>>|) after pressing 7 key twice.

* If you commit a mistake in the code entry, the unit enters the

code request mode again.

4. Press the Track Advance button on the remote to enter the override code.

5. The unit will enter the All Off or Standby mode if done properly.

Paidnfull,

Thanks for the info but how do get the unit out of standby mode. None of the buttons are responsive both on the head unit and the remote. Is there another sequence to follow during standby mode? Please advise.

By the way I have Kenwood KVT-715 indash dvd player I purchased online and needed to know how to get the unit out of standby mode.

Thanks