wiring a flip down monitor
Printed From: the12volt.com
Forum Name: Mobile Video, GPS, and Navigation
Forum Discription: Mobile Video Head Units, DVD Players, LCD and TFT Monitors, Navigation, GPS, PS2, PS3, XBox, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124834
Printed Date: May 10, 2024 at 11:58 PM
Topic: wiring a flip down monitor
Posted By: wire nut
Subject: wiring a flip down monitor
Date Posted: December 05, 2010 at 9:51 PM
I have a flip down seven inch monitor. I want to install it into my truck. The unit came from a 2001 Chevy Express van. The wires have been cut. So, I only have the end of the wires that go to the monitor. There are three connectors. One is an eight pin. The second is a twenty four pin and the third is a fourteen pin. I only want power and video input. The only thing that I know is that Clarion makes the monitor and that it is built into a GM overhead console with rear heater controls.
If anyone knows anything about this monitor or needs more detail, please let me know.
Thank you,
Don Z.
Replies:
Posted By: i am an idiot
Date Posted: December 05, 2010 at 10:21 PM
i am not at all familiar with that monitor. But most OEM equipment uses RGB input. There may not be a composite video input on the unit.
Posted By: wire nut
Date Posted: December 05, 2010 at 10:31 PM
I am just trying to figure out what each connector does. Then I can build a new harness. If I knew how to post a picture on here, would that help?
|