Viper 5305V and Flashlogic FLCAN
Printed From: the12volt.com
Forum Name: Mobile Video, GPS, and Navigation
Forum Discription: Mobile Video Head Units, DVD Players, LCD and TFT Monitors, Navigation, GPS, PS2, PS3, XBox, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142130
Printed Date: April 25, 2024 at 4:37 AM
Topic: Viper 5305V and Flashlogic FLCAN
Posted By: wyciwug
Subject: Viper 5305V and Flashlogic FLCAN
Date Posted: November 29, 2016 at 8:48 PM
Hello
I have a question. What is E-Brake status input and output?
Does anyone know where is that wire on the Viper 5305V?
Thanks
-------------
DCD
Replies:
Posted By: Ween
Date Posted: November 29, 2016 at 10:33 PM
Emergency/Parking Brake status....brake actuated, ground output.
On the Auxiliary/Shutdown/Trigger harness (White 24 pin connector)...pin 13, BLACK/ white.
Posted By: wyciwug
Date Posted: November 30, 2016 at 12:10 PM
I would like to connect the wires here and please can somebody help me to check if all connections are correct? Customer only wants me to hook it up for REmote start only, no alarm needed.
I will use Data Mode.
Thank you members
Remote Start, 10-pin Heavy Gauge to Car:
12 volts RED / black + Red+ RED / white to 12volt White in car (Dash fuse)
Starter Green and Violet to White in car (ignition sw pin 2) <<<<???
Ignition 1 Pink to White in car (ignition sw pin 3) also to Pink on FLCAN.
Ignition 2 Pink white or Pink black (?) to Pink in car <<<????
Accessory Orange to Red (ignition sw)
Auxiliary/shutdown/trigger 24-pin
Pin 10 Blue (-) trunk pin/instant trigger input to Yellow/red-Trunk status (-) output on FLCAN
Pin 13 BLACK/ white (-) Parking brake input to Green E-brake status (-) output on FLCAN Flash Logic
Flash Logic FLCAN connections:
Will connect them as shown in diagram. However, I have a question on the Relay connection #85 will be to ground or to ORANGE in the RS system 5-pin connector of the Main Harness?
-------------
DCD
|