VSS location for 2001 4Runner
Printed From: the12volt.com
Forum Name: Mobile Video, GPS, and Navigation
Forum Discription: Mobile Video Head Units, DVD Players, LCD and TFT Monitors, Navigation, GPS, PS2, PS3, XBox, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=18221
Printed Date: May 16, 2024 at 3:01 AM
Topic: VSS location for 2001 4Runner
Posted By: jhanses
Subject: VSS location for 2001 4Runner
Date Posted: August 29, 2003 at 6:45 AM
I'm installing a Pioneer AVIC-90DVD in my 4Runner and can't find the vehicle speed sensing unit. Can anyone help me with this? Also, why is it so hard to find a service manual on this vehicle?
Thanks,
John
-------------
4Runnin' MF
Replies:
Posted By: Chris Luongo
Date Posted: August 30, 2003 at 10:41 PM
Toyota speed sense is usually PURPLE / white...... and there's a cruise control module a little to the left of the steering column...... cruise must have a VSS wire in there, I would think.
Posted By: jhanses
Date Posted: September 02, 2003 at 11:30 PM
Thanks! I'm a newby - thought I'd get an email for reply. I ended up finding the VSS behind the glove box.
-------------
4Runnin' MF
Posted By: funglenn
Date Posted: September 23, 2003 at 9:19 PM
Does anybody know what color the VSS wire is behind the glove box? Is it PURPLE / white or is it GREEN/ ORANGE. Also what about the backup wire, my navigation system also wants to know when I am backing up.. Anybody know which wire to use and where and what color it is? I am soo close yet soo far.. Thanks
Posted By: jhanses
Date Posted: September 26, 2003 at 12:40 AM
I'm sorry I don't remember what the color was for the VSS but it was simple enough with a tester: Set it on AC volt (I was surprised at the AC advice but it works) then stick you tester into each line in the connecter, and test them one at a time by putting it in drive and/or reverse and just rolling a little bit. It will be obvious when you get the right one.
For the back up wire you just interupt the leads running to the rear of the vehicle and test for the one that controls your back up lights.
Hope that helps!
-------------
4Runnin' MF
Posted By: Chris Luongo
Date Posted: October 04, 2003 at 3:50 PM
funglenn,
If I'm looking for a wire, and I don't know the correct color, my first approach is to go directly to the component in question, even if that's where I don't plan to make my connection.
1. Gain access to the back of the taillamp, and obvserve the colors of the two wires going to the backup lightbulb. One of those is a ground; the other is the one you're looking for.
2. Go to a more convenient location in the car, such as the driver's kick panel, where you know there are a bunch of wires running toward the rear of the car.
3. Open up that wire bundle and locate all of the wires in there that are the correct color.
4. Test each of those wires until you get the right one.
Hint: Ground wires in Toyotas are usually brown, or BLACK/ white. So it's the other color at the reverse light bulb that you're after.
Posted By: my12volts
Date Posted: October 06, 2003 at 7:48 AM
to test if you have the speed sence wire ....just hook one side of ur meter to ground and the other to your wire ...then drive a few feet and your meter will change ...when you stop ur meter will too....
|