Eclipse BEC104

Printed From: the12volt.com
Forum Name: Mobile Video, GPS, and Navigation
Forum Discription: Mobile Video Head Units, DVD Players, LCD and TFT Monitors, Navigation, GPS, PS2, PS3, XBox, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=55358
Printed Date: May 04, 2024 at 9:35 AM

Topic: Eclipse BEC104

Posted By: Lizardking
Subject: Eclipse BEC104
Date Posted: May 08, 2005 at 5:04 PM

Made a big boo boo!! I installed my back up camara today and when running my cable which is a two piece cable the connectors got stuck on something. I tried forever it seemed to work it loose with no success. Anyway I ended up cutting the cable and soldered it back together was this okay to do? I never had to solder something like that before and I'm really good with soldering but not sure if you can solder video cable..

Thanks

Wires: Black, Red, Yellow and white (which was the outer insulation wire).

-------------
Eclipse "Approaching Perfection"

Replies:

Posted By: Lizardking
Date Posted: May 08, 2005 at 9:51 PM

I found out it doesn't matter at least I hope!!

-------------
Eclipse "Approaching Perfection"

Posted By: Ravendarat
Date Posted: May 08, 2005 at 10:53 PM

As long as it works and you arent getting any goofy interference than I guess you are good to go

-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer

Posted By: Lizardking
Date Posted: May 09, 2005 at 3:28 PM

I figure the two connectors that broke, all they where is crimped.. So I should have no problems....

-------------
Eclipse "Approaching Perfection"