Sorry for the newbie question but can someone tell where I might connect the "speed sensing" wire from a AVIC-N2 to a 04 Jeep Wrangler? (Rubicon edition if there is a difference).
Also if I can slide one more question in here, is there a preferred location on the Jeep to connect the "reverse sensing" wire? I was just going to take it to the rear lights but thought there might be a better way to do it.
Thanks for the help :D
VSS Wire: LOCATION 13- CONNECTOR ABOVE VALVE COVER HARNESS COMES FROM TRANSMISSION OR 4 CONNECTOR ECM GREEN CONNECTOR LIGHT GREEN / WHITE USE 250-4369
VSS Wire Color: WHITE/ ORANGE OR BLUE/ORANGE- LT.GREEN / WHITE
VSS Pulse: 8000 MANUAL 38600 AUTO
VSS Tach Wire: LOCATION 16- IGNITION COIL
Tach Signal Wire Color: GRAY OR GRAY/BLACK
metz,
Thanks for the reply, being a newbie at this I am a little confused. It looks like you gave me several options to connect the speed sensing wire to but I am unsure as to where they are located. It appears the ECM would be the easiest to locate and it looks pretty simple, just connect to the green connector, light green / white wire, but what does the 250-4369 mean?
"VSS Wire: LOCATION 13- CONNECTOR ABOVE VALVE COVER HARNESS COMES FROM TRANSMISSION OR 4 CONNECTOR ECM GREEN CONNECTOR LIGHT GREEN / WHITE USE 250-4369
VSS Wire Color: WHITE/ ORANGE OR BLUE/ORANGE- LT.GREEN / WHITE
VSS Pulse: 8000 MANUAL 38600 AUTO"
Thanks again for the help