AVIC-N2 screen folding issue

Printed From: the12volt.com
Forum Name: Mobile Video, GPS, and Navigation
Forum Discription: Mobile Video Head Units, DVD Players, LCD and TFT Monitors, Navigation, GPS, PS2, PS3, XBox, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85040
Printed Date: May 02, 2024 at 4:24 AM

Topic: AVIC-N2 screen folding issue

Posted By: grandcherokee01
Subject: AVIC-N2 screen folding issue
Date Posted: November 02, 2006 at 8:41 PM

Hello All,

I just replaced the ribbon cable in my N2 unit because the screen stopped working and my buttons weren't working as well. For some reason though now my unit will not tilt the screen up. It will come all the way out sucessfully but will not tilt. Any suggestions on what to look for or what might have caused the problem?

Thanks

-------------
Jeep Grand Cherokee '01
Infinity Gold System
Pioneer AVIC-N2 w/ rear view camera and iPod Adapter
2 8x10 LCD Headrest Monitors
2 5x7 LCD Headrest Monitors
2 JL 10 W7's, 500\1 Mono AMPS
5 Farad C

Replies:

Posted By: i am an idiot
Date Posted: November 02, 2006 at 9:37 PM

Been a while since I did one but doesn't the ribbon cable have 3 connections on it? A large connector to the radio board, a large one to the screen and a small one to the screen? If so I would check the smaller connection 1/2 to 3/4 inch wide. Look at it and make sure it is squared into the plug and also make sure the lock is secure and cable won't pull out of it.

Posted By: tedoneal
Date Posted: November 03, 2006 at 9:19 AM

you broke the lift switch due to improper uninstallation