prostart ct-3310
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137997
Printed Date: April 28, 2024 at 4:17 PM
Topic: prostart ct-3310
Posted By: mike31
Subject: prostart ct-3310
Date Posted: December 18, 2014 at 9:39 AM
HI EVERYONE NEED HELP
I have a remote starter CT-3310 which has been working fine last winter but now when I use the remote to start ,it start and crank the engine 3 times and shuts down also I tried to flash the pin hood to re teach tach programming the parking lights does not come on at all.
I thank you all for any suggestion. Mike
Replies:
Posted By: tedmond
Date Posted: December 19, 2014 at 9:21 PM
you have a bypass problem. Its not a tach issue. what vehicle?
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: tedmond
Date Posted: December 19, 2014 at 9:23 PM
where abouts are you located?
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: mike31
Date Posted: December 20, 2014 at 12:56 AM
Thanks for the reply Ted. I installed the unit myself about 4 years back and never had problem with it. I have checked the unit and the connections seems to be ok. The car is chevy cavalier 2005 and I am selling the car to one of my co-worker but it would be nice that remote start also works well. I live in Aurora. Once again thanks for the reply.
Regards Mike
Posted By: tedmond
Date Posted: December 20, 2014 at 6:11 AM
what bypass module are you using? or did you use a resistor for passlock
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: mike31
Date Posted: December 20, 2014 at 3:06 PM
HI TED
I can not remember the name of the bypass unit , no I did not use resistor circuit I will tel you the name of the bypass unit in the next post.Thank you
Regards Mike
Posted By: mike31
Date Posted: December 20, 2014 at 3:29 PM
I have found the document of bypass unit is called PLJX GM PASSLOCK
Posted By: mike31
Date Posted: December 20, 2014 at 5:08 PM
HI TED
I have tried to locate the bypass module but it seems that is missing.The car was given to my nephew and I think is fallen off of the connector, probably thrown out during interior clean up .If you have resistor circuit for the bypass can you please post it.
Regards Mike
Posted By: yellow_cake
Date Posted: December 20, 2014 at 7:53 PM
The resistor circuit is on this site. Here's a link to one of the threads: https://www.the12volt.com/installbay/forum_posts.asp?tid=135279
Since the wiring is already there, it would be much easier to just buy another module and program it. Be sure to secure it so it doesn't fall off.
Posted By: mike31
Date Posted: December 20, 2014 at 8:35 PM
HI TED
Thanks for all your support. I found the bypass kit, connected to connector ,reprogrammed and remote starter works great.
All the best
Regards Mike
|