Name:	Geir Dalamomo
E-mail:	dalamomo@sensewave.com
Homepage:	http://none yet
Date:	June 04, 2000
City:	KOPPANG
State:
Country:	Norway
How you found me:	Search Engine
Wrote... I love this site. Have doing a lot of the same work as you since 1982, all kind off stuff. It is in the 90`s i started whit UScars,not so happy about that all the time , probely this site will help me.

Name:	Edward F. Cooke
E-mail:	ekooke69@yahoo.com
Date:	June 01, 2000
City:	Iola
State:	Kansas
Country:	United States
How you found me:	Search Engine
Wrote... Hi, I'm looking for a diagram of a relay harness that will work on a Toyota 2 headlight system. They all use ground switching, unlike almost all other cars. I've wired a harness using the conventional instructions, and it works, but the problem is that the low beam filaments won't go out when the high beams are switched on. Is there a way around this, AND still have flash-to-pass capabilities? Thank you for your help.

Name:	Lanner
E-mail:	lanner.T.Fayad.1@nd.edu
Date:	May 31, 2000
City:	S. BEnd
State:	Indiana
Country:	United States
How you found me:	Search Engine
Wrote... I have an UNGO alarm that I am trying to install. I don't which wire goes where from the alarm to the car. I need directions, or diagrams. Thank you so much.

Name:	MIHAI GOLLI
E-mail:	MGOLLI@personal.ro
Date:	May 31, 2000
City:	BUCURESTI
State:
Country:	Romania
How you found me:	Search Engine
Wrote... IS VERY GOOD

Name:	Halldóra Skúladóttir
E-mail:	success@wealth-for-u.com
Homepage:	http://www.wealth-for-u.com
Date:	May 28, 2000
How you found me:	the12volt.com is my default start page!
Wrote... US/International needs contacts all over !

Name:	mario garza
E-mail:	ZUMAPUPPY@HOTMAIL.COM
Homepage:
Date:	May 27, 2000
City:	san diego
State:	California
Country:	United States
How you found me:	Search Engine
Wrote... my problem is that i have (4) 110,000uf caps in parallel at is connected (4ga cable)from the battery to a dist. block to 2 amps. i have a lose of power after a couple of days to the battery. the caps are ground in parallel to the chassis. i just downloaded the section on momentary to constant output relays. i want to set relays to be powered by the amp triggered in the head unit once i turned the ign. key. i really do not want to use a man. circuit breaker like roc/fos. what my be your thoughts on this. thanks for the response. great site!!

Name:	Ebinger
E-mail:	bbkorn44@aol.com
Date:	May 24, 2000
City:	Sharon Hill
State:	Pennsylvania
Country:	United States
Wrote... Car Audio is the *hit

Name:	Mainor Moscoso
E-mail:	mainormoscoso@yahoo.com
Date:	May 23, 2000
City:	Raritan
State:	New Jersey
Country:	United States
How you found me:	Search Engine
Wrote... Great information, one of the best sites that i found regarding auto security keep up the good work man

Name:	hernan
E-mail:	trinitrotolueno@icqmail.com
Date:	May 21, 2000
City:	buenos aires
State:
Country:	Argentina
How you found me:	Search Engine
Wrote... *BEEP* o i have twenty years and i like installing car audio thanks very much for the information here it was very usefull to me

Name:	Mark James
E-mail:	PureKelso@aol.com
Date:	May 19, 2000
City:	Bristow
State:	Oklahoma
Country:	United States
How you found me:	You're kidding, right? I used a computer!
Wrote... Way cool site! I am a wiindow tinter/alarm installer, and your site has helped me on multiple occassions. Thanks

Name:	peter dillon
E-mail:	pdillon1@hotmail.com
Date:	May 17, 2000
City:	dublin
State:	Louisiana
Country:	Ireland
How you found me:	Search Engine
Wrote... where does the red wire go??

Name:	Raul Magana
E-mail:	www.playaE1@aol.com
Date:	May 16, 2000
City:	modesto
State:	California
Country:	United States
How you found me:	Other
Wrote... This is a great website this is just what I was looking for. I would like to get a wire diagram on a 94 ford T-bird for remote start thanks.

Sign Guestbook !