factory alarm disarm, 2010 ford fusion sport
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136480
Printed Date: November 04, 2025 at 5:41 AM
Topic: factory alarm disarm, 2010 ford fusion sport
Posted By: dwiz
Subject: factory alarm disarm, 2010 ford fusion sport
Date Posted: April 19, 2014 at 1:10 PM
I have a 2010 Ford fusion sport AWD. I want to intall a one-button remote start only unit in the vehicle. I haven't decided if I will use the viper or python unit yet, they seem to be virtually the same. I know I will need the bypass for the immobilizer no matter which I choose, my question is regarding the factory passive alarm. Will I need to connect the "disarm factory alarm" wire on the unit to my vehicle? If so, wiring codes I have found here and elsewhere say disarm is with factory key fob only, so how would I go about doing this? I wasn't sure if the bypass for the key immobilizer took care of this or not. Any help is appreciated, thank you.
Replies:
Posted By: kreg357
Date Posted: April 19, 2014 at 1:29 PM
Posted By: chev104275
Date Posted: April 19, 2014 at 5:00 PM
I've only done a few fusions but I've done a bunch of Lincoln mkz's which are the same. You don't need to hook up a disarm wire doing a single button start. When the car see's ignition and a valid key signal it disarms the alarm.
-------------
If i Can't Install it I Don't need it Joe
Posted By: pentavolvo
Date Posted: April 19, 2014 at 7:09 PM
chev104275 wrote:
I've only done a few fusions but I've done a bunch of Lincoln mkz's which are the same. You don't need to hook up a disarm wire doing a single button start. When the car see's ignition and a valid key signal it disarms the alarm.
Agree 100%
|