I have a Compustar 2WSS-AS remote starter installed on my 07 Highlander. When remote starting, the SRS airbag lights stays on. When I start with my manual key, the SRS light does not stay on. My car has a 2nd Starter and 2nd Ignition wire. Compustar only has a pre-wired relay to connect to a 2nd Starter and 2nd Ignition wire. I chose the 2nd Starter.
How do I get fix the SRS light?
Should I disconnect the 2nd starter and used the 2nd Ignition wire instead?
Do I need to add another relay? If so how?
Here is the wiring diagram for the Highlander if you need to look at it:
https://www.the12volt.com/installbay/forum_posts.asp?tid=66777There are additional out puts for second EVEYTHING, they are on connector 2 I believe.
second starter in RED / blk
second ign is green. Remember, these are low amperage NEG(-) outputs, you will need to use relays. (Im sure you know that, but I had to say it!)
-------------
KarTuneMan wrote:
There are additional out puts for second EVEYTHING, they are on connector 2 I believe.
second starter in RED / blk
second ign is green. Remember, these are low amperage NEG(-) outputs, you will need to use relays. (Im sure you know that, but I had to say it!)
I thought you were only able to use one of the following: 2nd ignition, 2nd Accessory, or 2nd starter. I didn't think you were able to use all 3 if needed.
To fix my problem, I added an extra relay for the 2nd ignition and the SRS light went away.
Thanks for the info KarTuneMan.