*All information on this site is provided "as is" without any warranty of any kind,
either expressed or implied, including but not limited to fitness for a particular use. Any
user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
1989-90 Nissan Sentra Cruise Control Wiring Information
Constant 12V+
White/Red
Ignition Switch Harness or Use Hot Side of Brake
Switched 12V+
Black/White
Ignition Switch Harness
Ground
Use Chassis
Near Cruise Control Module
Hot Side of Brake
n/a
Brake Switch
Cold Side of Brake
Green/Black (-)
Brake Switch
Tach
Black/Red
Coil
VSS Wire
White/Blue
ECM, Driver's Side of Console16 Pin Connector
Pulses Per Mile
2000 PPM
Notes: Vehicles with Manual Transmission require Clutch Switch. Some vehicles may require a speed signal generator and/or other parts/adapters not listed above.
Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.