wiring diagram for a 2001 jeep

Hey Guys im installing a remote start in my wifes 2001 jeep could someone please email with a site to get the color codes in the steering colum. Thanks Scott 

what kind of jeep is it? if it's a grand cherokee and you plan on also doing an alarm and keyless entry...you're going to need a 455J from DEI. Also, you're going to need either a 555C or a 555U to bypass the factory security system. but...

Cherokee

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

|              12V|red & pink/black    |+  |ignition harness            ||          STARTER|yellow              |+  |ignition harness            ||         IGNITION|dark blue           |+  |ignition harness            ||  SECOND IGNITION|BLACK/ orange        |+  |ignition harness            ||        ACCESSORY|BLACK/ white         |+  |ignition harness            ||       POWER LOCK|ORANGE / purple *2    |-  |drivers kick panel          ||     POWER UNLOCK|pink/purple *2      |-  |drivers kick panel          ||       LOCK MOTOR|see direct fax      |   |                            ||     UNLOCK MOTOR|document #1074      |   |                            || PARKING LIGHTS +|BLACK / YELLOW        |   |headlight switch *3         ||       HEADLIGHTS|lt. green           |+  |steering column             ||     DOOR TRIGGER|yellow              |-  |drivers kick *4             ||  TRUNK/HATCH PIN|tied in with door   |   |                            ||       TACHOMETER|gray                |   |black plug at PCM *1        ||       BRAKE WIRE|WHITE/ tan           |+  |brake switch                ||     HORN TRIGGER|BLACK/ red           |-  |steering column             ||           WIPERS|                    |   |                            ||  LF WINDOW UP/DN|lt. blu - white     |A  |drivers door switch         ||  RF WINDOW UP/DN|brn/wht - pur/wht   |A  |drivers kick panel          ||  LR WINDOW UP/DN|blu/wht - RED / blk   |A  |drivers kick panel          ||  RR WINDOW UP/DN|gry/blk - grn/wht   |A  |drivers kick panel          |

Notes:

NOTE:  Jeep vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting.  Use DEI part number 555C or 555U.  *1 The PCM (powertrain control module) is located on the drivers side inner fender well near the radiator support.     *2 Must use relays to trigger the lock and unlock wires.  Close all doors when testing.  *3 Also found in a large connector at the junction block in the passenger kick panel.  *4 In a gray 2 pin connector.

GRAND CHEROKKE

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

|              12V|red & pink/black    |+  |ignition harness            ||          STARTER|yellow              |+  |ignition harness            ||         IGNITION|dk. blue            |+  |ignition harness            ||        ACCESSORY|RED / black           |+  |ignition harness            || SECOND ACCESSORY|BLACK/ orange        |+  |ignition harness            ||       POWER LOCK|orn/blk - orn/pur *7|5wi|door lock switches *1       ||     POWER UNLOCK|pnk/blk - pnk/pur *7|5wi|door lock switches *1       ||       LOCK MOTOR|ORANGE / black        |   |drivers door lock switch    ||     UNLOCK MOTOR|pink/black          |   |drivers door lock switch    ||    DISARM DEFEAT|pink/purple         |   |passenger kick panel        || PARKING LIGHTS +|use (-) lights      |   |                            || PARKING LIGHTS -|dk. blue/pink *2    |   |steering column             ||       HEADLIGHTS|yellow              |*3 |at the headlight switch     ||     DOOR TRIGGER|*4                  |-  |*4                          || DOME SUPERVISION|yellow/dk. green *7 |-  |BCM, above diagnostic plug  ||  TRUNK/HATCH PIN|tan/black           |-  |BCM, above diagnostic plug  ||  FCTRY ALARM ARM|arms with lock *7   |   |                            ||FCTRY ALRM DISARM|lt. GREEN/ orange *7 |-  |*5                          ||       TACHOMETER|*6                  |   |*6                          ||      SPEED SENSE|WHITE/ orange        |   |PCM, passenger side firewall||       BRAKE WIRE|WHITE/ tan           |+  |drivers kick panel          ||     HORN TRIGGER|gray/orange         |-  |steering column             ||           WIPERS|dk. GREEN/ red       |-  |steering column             ||  LF WINDOW UP/DN|lt. blue - white    |A  |drivers door lock switch    ||  RF WINDOW UP/DN|brown - purple      |A  |passengers door lock switch ||  LR WINDOW UP/DN|dk. blue - RED / wht  |B  |drivers kick panel          ||  RR WINDOW UP/DN|gray - dk. green    |B  |passengers kick panel       ||        RADIO 12V|RED / white           |   |at the radio                ||     RADIO GROUND|black               |   |at the radio                ||     RADIO SWITCH|WHITE/ red           |   |at the radio                ||       LF SPEAKER|grn/orn - brn/red   |   |at the radio                ||       RF SPEAKER|purple - blu/pnk    |   |at the radio                ||       LR SPEAKER|wht/grn - grn/wht   |   |at the radio                ||       RR SPEAKER|grn/wht - blu/orn   |   |at the radio                |

Notes:

NOTE:  Jeep vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting.  Use DEI part number 555C or 555U.  *1 Use ORANGE / black and pink/black at the drivers door lock switch to lock and unlock the drivers door.  Use ORANGE / purple and pink/purple at the passengers door lock switch to lock and unlock all of the other doors.   *2 The dk. blue/pink will flash the hazard lights.  They will flash even with a latch input to the wire.  The parking lights can be activated by using a 1300 ohm resistor to ground on the yellow headlight wire.   *3 Use a 330 ohm resistor to ground for headlight activation.  Use 80 ohms to ground on the same wire to operate both the headlights and parking lights.  *4 There are 4 separate door triggers wire, one for each door.  Use all 4 wires and diode isolate each together.  The drivers door is tan/red at the drivers door lock switch. The passenger door is tan/red at the passengers door lock switch.  The drivers rear door is tan/orange and the passengers rear door is tan / YELLOW at the BCM. WHEN USING A 455J INTERFACE MODULE, IT IS NOT NECESSARY TO USE THE SEPARATE TRIGGER WIRES. USE THE YELLOW WIRE AT THE UNDERDASH LIGHT FOR DOOR TRIGGER.  *5  Factory alarm disarm requires a 463 ohm resistor to ground on the lt.GREEN/ orange wire at the drivers door lock switch, you MUST use a relay.  *6 The 4.7L motor has a separate coil for each cylinder.  Go to any coil and use any wire that is NOT dk. GREEN/ orange.  On the 4.0L motor use any of the tan/stripe wires at the coil pack, or go to one of the fuel injector and use the wire that is NOT dk. GREEN/ orange.  *7 Can also use DEI part number 455J door lock interface control module. This will control door lock, unlock, arm, disarm, dome light supervision and more.

I take no responsibility for these wiring diagrams and they are to be used at your discresion. I am not responsible for any damages incurred in the process of installation or of the outcome. GOOD LUCK AND ENJOY!