the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

rf t10001bd


Post ReplyPost New Topic
< Prev Topic Next Topic >
michael213 
Member - Posts: 34
Member spacespace
Joined: May 20, 2007
Location: United States
Posted: January 03, 2008 at 8:29 PM / IP Logged  
IDoes any one know what kind of wire goes from the amp to the PPB1 controller for this amp? I think it is normal networking cable but unsure. Any one know for sure?
michael213 
Member - Posts: 34
Member spacespace
Joined: May 20, 2007
Location: United States
Posted: January 03, 2008 at 8:53 PM / IP Logged  
One more question about the Rockford Fosgate T10001BD amp is if it is mono then why is there a speaker A + and - and speaker B + and -? Can I use these both as and bridge like a normal amp? Or just use one set and run the speaker the same as normal? I am currently running one 2ohm DVD sub I have wired to a 1 ohm load. Any sugestions?

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer