help on a rattler

What do you need help with ?Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Here is  a wiring diagram, use it as a reference to what you have and see if there are any wires that you have missed. Also, we need more information as to what you mean by your post above:

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

|              12V|white & WHITE/ red   |+  |ignition harness            ||          STARTER|black               |+  |ignition harness            ||         IGNITION|BLACK/ red           |+  |ignition harness            ||  SECOND IGNITION|BLACK / YELLOW        |+  |ignition harness            ||        ACCESSORY|blue/red            |+  |ignition harness            ||       POWER LOCK|gray *1             |-  |white plug near fusebox     ||     POWER UNLOCK|purple *1           |-  |white plug near fusebox     ||       LOCK MOTOR|blue/white          |   |DKP, 12 pin plug in pin 10  ||     UNLOCK MOTOR|blue                |   |DKP, 12 pin plug in pin 11  ||    DISARM DEFEAT|blue                |   |PKP, 12 pin plug in pin 9   || PARKING LIGHTS +|green               |   |back of fusebox, 12 pin plug|| PARKING LIGHTS -|PURPLE / red          |   |front of fusebox,22 pin plug||       HEADLIGHTS|*2                  |-  |front of fusebox,22 pin plug||     DOOR TRIGGER|*3                  |-  |front of fusebox,22 pin plug|| DOME SUPERVISION|comes on with unlock|   |                            ||       TACHOMETER|lt. GREEN/ black     |   |instrument cluster or *4    ||      SPEED SENSE|GREEN/ orange        |4  |ECM behind the glove box    ||       BRAKE WIRE|GREEN / WHITE         |+  |brake pedal switch          ||     HORN TRIGGER|GREEN/ red           |-  |steering column             ||           WIPERS|blu/blk(L),RED / wht(H|+  |steering column             ||  LF WINDOW UP/DN|blue - blu/yel      |A  |driver window switch        ||  RF WINDOW UP/DN|RED / blk - RED / grn   |A  |DKP, 12 pin plug            ||  LR WINDOW UP/DN|RED / blu - blu/blk   |A  |DKP, 13 pin plug            ||  RR WINDOW UP/DN|yellow - lt. green  |A  |DKP, 13 pin plug            ||        RADIO 12V|blue / YELLOW         |+  |radio                       ||     RADIO GROUND|brown               |-  |radio                       ||     RADIO SWITCH|gray                |+  |radio                       || RADIO ILLUMINATE|GREEN/ red           |+  |radio                       ||       LF SPEAKER|pink - purple       |   |radio                       ||       RF SPEAKER|lt. green - blue    |   |radio                       ||       LR SPEAKER|black - yellow      |   |radio                       ||       RR SPEAKER|red - white         |   |radio                       |

Notes:

*1 These wires will test only by operating the key in the passenger door lock cylinder, not the rocker switch on the door.  *2 Vehicles without Daytime Running Lights it is RED / blue. Vehicles with DRL it is RED / green.  *3 The driver door trigger is green, the front passenger door trigger is GREEN / WHITE, and the rear door trigger is YELLOW /GREEN. Use all three wires and diode isolate each.  *4 On the 4 cyl it is at the data link connector to the right of the steering column. On the V6 it is at the igniter on the passenger fender, below the air filter box.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Just one piece of advise don't call DEI for help they only give you a 48 hour window for any tech support. Just stick to this forum and cross your fingers you don't have any problems later on. Also I installed one on a 2003 Corolla and had a hard time getting the programing instuctions I needed to program the crank time. Hope you don't have the same trouble I had. Next time get another brand even if it is a cheap Bulldog.

Did you ground the Black \ White neutral safety switch of the remote starter???

 it needs to see ground for remote starter to operate.

Luis

Sound Waves

Is up to the installer to test all wires with a DMM whenever possible.

What happens when you press the start button? Anything? There are so many possibilities that could be wrong or just need to be done before it will try to start. If the alarm brake wire sees 12v+ it wont start, same if the hood pin sees ground or the neutral safety wire does not see ground. Did you hook up the tach signal and then learn the tach or are you using voltage sensing mode? There are more possibilities, but these are all things that you need to be sure of.J Rilla

Owner/Installer