2013 Grand Caravan DBALL2 RSR 3X Lock

Home / the12volt's Install Bay / Car Security and Convenience / 2013 Grand Caravan DBALL2 RSR 3X Lock

Welcome Guest :)

Members

< Prev Topic Next Topic >

rlxndr73

Member - Posts: 1

Joined: November 06, 2015

Location: New Brunswick, Canada

Posted: November 06, 2015 at 8:33 AM / IP Logged

I just installed a pre-programmed DBALL2 to start my Grand Caravan from the factory FOB. When I hit lock 3x, the DBALL2 starts flashing green, I hear a relay click and then click again a short time later. The engine does not crank during this period. After three attempts, the parking lights flash three times, then the doors lock if not locked already.

I'm using the CHDHT1 harness with only the parking lights wired. The door trigger, and hood switch (WHITE/ black) wire are not connected or grounded.

Interestingly, when I check the options/functions, I have 10 options returned instead of only the 9 listed in the literature.

Any ideas? Incorrect firmware?

Goodyear

shark mobile

Copper - Posts: 83

Joined: November 22, 2014

Location: Ontario, Canada

Posted: November 16, 2015 at 6:48 PM / IP Logged

If you're using a harness you have to assume it's the programming...try reprogramming the unit to the vehicle. Could just be a simple learn issue:)

Solder, tape, repeat!

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.