2003 Dodge Ram 1500 Quad Cab Remote Start

I installed an AviStart 3300 in a 2003 Dodge Ram 1500 Quad Cab.  When I remote start the truck, sometimes the A/C compressor kicks in and some times it doesn't, the blower always comes on, sometimes the ABS and parking Break light stays on, and to top it all off the 'Check Engine' light came on after a few minutes of driving.  What I want to know is, did I screw up the computer, by not have all of the ignition and accessory wires connected.  Can someone tell me what I did wrong?

The only wire I have hooked up to the remote start unit is GREEN & ORANGE, YELLOW which is the starter, and the regular power wires and that’s it.  The radio does not come on (BLACK/ WHITE wire).

What other wires do I need to connect, and do I need Diodes and Relays?

If nobody can help, Could I get a Wiring Diagram for the truck?

The guy is new here . Instead of spending time complaing why dont you guys do what you came here to do give help or get help.You could have posted a link quicker than it took you write your post.

https://www.the12volt.com/installbay/forum_posts.asp?tid=12769&KW=2003+dodge+ram

Also the link to the search is at the top of the page . Good Luck.

IT WORKED!... Only one thing happened. I did a diagnostic on the truck when it was started remotely, and started with the key.  When started remotely the only error message I got was a failer to receive data to instrument cluster; (probably just the seat belt sensor and other things on the instrument cluster), and with the key, no errors. So it works fine. No more check engine light, and the A/C works, those were my only concerns.

Thanks again!

The Color Was Red With White it was on the ignition harness, but that doesn't mean that it will be the same in yours it may also be just red. Check it with a test light, make sure your getting 12v in "On" and "Crank" positions.

Follow the Wiring Diagram in this Post.

https://www.the12volt.com/installbay/forum_posts.asp?tid=12769&KW=2003+dodge+ram