530t

I have just completed the install on a 530t and things seem to work fine. The question I have is can you have one touch at the driver side and passanger side for the passanger window. I hooked allof my leads up at the master switch on my 94 Blazer and I have one touch at the drive side, but not at the passanger side. When I hooked up the leads from the passanger side on to the leads from the driver side neither side worked. I could cut the leads from the driver side and the passanger side would work, but not the driver side. I would like to have one touch on both sides if possible.bassop

it works like this. if were to hook up your wires in the drivers and pass door then, the driver would have one touch for his window and the passenger would have on touch for thier window. since you did them both at the drivers, only you can control the auto up-down. and theres will be normal. understand.

I understand, but what I am asking is can both sides have one touch for the passanger window?bassop

yes, but you need to connect the wires for the passenger side window in the passenger door at the motor.

So let me get this right. If I run the wires to the passenger side I should have one touch control for the passanger side from the drive side and passanger side. Also I installed this in a vehicle that I mainly drive on the weekends. I got done on Sunday evening and went out tonight to start the truck and the battery was dead. I know it could  be just the battery or something else, but I was wondering if any one had this problem on a 530t. Also I was wondering if anyone knew how the ground alarm wire worked. What I mean is I know that the windows roll up when the alarm is armed and shut off when the resistance gets to a certain point. When my windows go up I can hear the relays click to turn off the window motors, but do they try to restart because they see ground.bassop