the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2001 Grand Am, door lock wires


Post ReplyPost New Topic
< Prev Topic Next Topic >
exit69 
Copper - Posts: 53
Copper spacespace
Joined: May 06, 2002
Location: Canada
Posted: April 25, 2005 at 7:45 PM / IP Logged  
I think everything will work fine... I had the wrong resistor :( I will get a 1500 ohm resistor tomorrow and it should work.
One last thing...
My security light is now always on. Can anyone tell me the most common reasons? or where to start looking...
The car starts and runs perfect with the remote starter and I am pretty sure I set the passlock bypass unit to the perfect voltage :(
exit69 
Copper - Posts: 53
Copper spacespace
Joined: May 06, 2002
Location: Canada
Posted: April 25, 2005 at 8:35 PM / IP Logged  
I think everything will work fine... I had the wrong resistor :( I will get a 1500 ohm resistor tomorrow and it should work.
One last thing...
My security light is now always on. Can anyone tell me the most common reasons? or where to start looking...
The car starts and runs perfect with the remote starter and I am pretty sure I set the passlock bypass unit to the perfect voltage :(
exit69 
Copper - Posts: 53
Copper spacespace
Joined: May 06, 2002
Location: Canada
Posted: April 29, 2005 at 7:25 PM / IP Logged  
The doors worked. I just had the wrong resistor.
Now two last things... the security light is always on. I tried disconnecting the battery over night but that didn't shut it off. Any other ideas?
Also, the last wire I need is either a trigger wire or the dome light supervision wire. I know their colors and where they are, like it says white wire in the dash or consol for the dome light wire... and lt GREEN/ blk drivers kick panel but there are many and I tried them all to see current when the door is open but I couldn't find the right one. Any one have any tips or better details on finding one of these wires?
Thansk
iskidoo 
Silver - Posts: 1,043
Silver spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: December 08, 2002
Location: Maine, United States
Posted: May 01, 2005 at 12:02 PM / IP Logged  
Try finding the white wire at one of the under dash lights, you need a to see a ground when the door is open not current. place your positive lead on 12 volts constant and the negative lead of your meter on the wire then push the door pin switch or open the door to test it.
Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer