command start programing

Home / the12volt's Install Bay / Car Security and Convenience / command start programing (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

muaiad97

Copper - Posts: 207

Joined: April 08, 2003

Location: Canada

Posted: November 21, 2005 at 8:48 PM / IP Logged

hi evryone

i have command start remot starter cs310i anyone has the programing instruction or user manual.

thanx

stang351w

Silver - Posts: 350

Joined: August 20, 2003

Location: Canada

Posted: November 21, 2005 at 9:04 PM / IP Logged

check out grandwestauto.com (beleive that's right) i got infor on a cs250i from there, unless it's really new then you might have luck finding automobility distribution a good place to go...there located in montreal

Tri County KustomZ

certified installer

05gt

Silver - Posts: 628

Joined: October 30, 2005

Location: British Columbia, Canada

Posted: November 21, 2005 at 9:05 PM / IP Logged

what programming do u have to do

stang351w

Silver - Posts: 350

Joined: August 20, 2003

Location: Canada

Posted: November 21, 2005 at 9:07 PM / IP Logged

prob for the tach settings and single or double pulse door locks...little stuff like that.. i didn't mind programming the tach...but it wasn't as easy as the autostarts

Tri County KustomZ

certified installer

muaiad97

Copper - Posts: 207

Joined: April 08, 2003

Location: Canada

Posted: November 21, 2005 at 9:20 PM / IP Logged

thanx guys

just user manual wiring istructions

05gt

Silver - Posts: 628

Joined: October 30, 2005

Location: British Columbia, Canada

Posted: November 21, 2005 at 9:20 PM / IP Logged

if you want to program tach

hold the hoodpin down for 4 seconds, let it up, then press down and then up, the parklights will stay on

go inside the vehicle and press the brake, while holding the brake down press the lock and unlock buttons on the remote and hold untill the lights flash 5 times release brake

start the vehicle with the key and let it reach proper idle, when this happens press and hold the brake once more, when tach has been detected the lights will once again flash 5 times

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

command start programing

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.