2006 toyota corolla

 Hi , I Have a problem when installing heater blower wire for toyota cars,Everything works fine but the heater blower will not come on when remote start so i dont have heat or Ac .But come on when i switch the key on ,The funny thing is i use the wire chart and it say Blue/Red which i found at  (ign Harness) but dont work ,Am i doing something wrong please help me . thanksChris

sorry forget to mentioned  its 2006 toyota corollaChris

Did you connect both ignition wires?      WIRE          COLOR          POLARITY          LOCATION                Battery          BLACK          (+)          IGNITION SWITCH HARNESS                Ignition 1          BLACK/ WHITE          (+)          IGNITION SWITCH HARNESS                Ignition 2          BLACK / YELLOW          (+)          IGNITION SWITCH HARNESS                Accessory 1          BLUE/RED          (+)          IGNITION SWITCH HARNESS                Starter 1          RED          (+)          IGNITION SWITCH HARNESS                Anti-Theft Type          UNIVERSAL IMMOBILIZER                Anti-Theft Descript          THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER                Key Sense          BLUE/BLACK          (-)          IGNITION SWITCH HARNESS                Tachometer          BLACK          (-)          AT ECM                Speed Sense          VIOLET/WHITE          (AC)          AT ECM SECOND PLUG FROM RIGHT PIN 17                Parking Lights          GREEN          (+)          DRIVER KICK                Low Crr. Pk Lights          GREEN / WHITE          (-)          AT HEAD LIGHT SWITCH                Brake Lights          GREEN / WHITE          (+)          AT SWITCH ABOVE BRAKE PEDAL                Reverse Lights          RED / BLACK          (+)          VEHICLE FUSEBOX                Horn          GREEN/ YELLOW          (-)          IGNITION SWITCH HARNESS                IMO          BLACK                IMI          WHITE                Rear Defrost          BLACK

The blue/red is just for the radio and other accessories. Not even necessary during remote start. I prefer to leave it disconnected to keep the radio quiet while the car's running in the driveway.....your choice there. However, you must not have one of the ignition wires connected. The BLACK/ white and BLACK / YELLOW Ignition 1 and 2 wires BOTH need to see power during remote start. I think it's the BLACK / YELLOW that powers the HVAC.