remote start for 06 mazda 3

The brown wire is hooked up to the ground when running wire. Is there something I need to do with the valet switch. I seem  to remember the guy that put this in my car he was trying to get to work with one key. He was pushing the switch so many times and then turned the key so many times. I don't know if this is right or if I saw thing wrong just hope to figure this thing out.

It sounds to me like you may not even have a bypass issue yet. You first need to get the unit to try to remote start the car. If it tries to start the car and the car just cranks, then you have a bypass issue. Do you have the owners manual? I am not familiar with Autopage units. The unit may be in valet mode if it won't attempt to remote start the car. I looked at an owners manual for a different Autopage unit in the Downloads section. It says to turn on/off valet mode turn the ignition on and then hold the valet button for two seconds. If the l.e.d. is on then it is in valet mode, if its off it is not in valet mode. Do you have an l.e.d. installed? Is it on or off?

The car never cranks over, and is not in valet mode I checked that frist. I got the operations manual, but I didn't get any thing for the installation. Is anyone know anything about the rs-622 from autopage?

I tried unpluging the bypass with a key in and it didn't do anything. The only thing that happens when I hit the start button on the lcd remote it beeps three time, and that's it.

Without knowing the product RS622, it sounds like valet mode......Sylvain Rochon

MECP security specialist

Tech support for remote starters

26 Years of experience counts

I'm here to help.

That is one thing i know it is not. I can put it in valet mode and it shows on the lcd remote.

If by "it doesn't do anything" you mean that the parking lights don't flash at all like the car's going to start - check the hood switch input(this should NOT be grounded) and the neutral safety input(this MUST be grounded). If you mean that the parking lights flash, dash lights come on like they would with the key turned to run, but the car doesn't crank - this would indicate a problem with the bypass.C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two

The only thing that happens is my remote beeps three time no lights. The guy that installed this didn't hook up the hood switch. I would hook one up myself, but don't have and can't find the installation manual anywhere.

The problem here sounds like either the remote isn't programmed properly(does it work the door locks at all?) or the hood switch wire is grounded, or the neutral safety wire is NOT grounded. Forget about the bypass for the time being.C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two