Need help with 2000 Ford Windstar Dome Li

Home / the12volt's Install Bay / Car Security and Convenience / Need help with 2000 Ford Windstar Dome Li (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

RebelShadow

Member - Posts: 4

Joined: April 03, 2003

Location: United States

Posted: April 03, 2003 at 4:59 PM / IP Logged

I have recently installed an AudioVox APS-996 system on my 2000 Ford Windstar. I connected the door trigger to the ORANGE / white wire located at the FEM. My guide says to connect the dome supervision to the BROWN / pink located at the passenger D pillar. I have looked for the wire but can not find any BROWN / pink wire on that side of the van. Is this wire there or is it another color? An exact location would be of great help too.

Thanks, RS

rebelshadow@earthlink.net

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: April 03, 2003 at 10:25 PM / IP Logged

Constant 12 volts L GREEN/ VIOLET & RED IGNITION SWITCH HARNESS

Ignition 12 volts WHITE/ YELLOW IGNITION SWITCH HARNESS

Starter D GREEN IGNITION SWITCH HARNESS

Dome Light BROWN / PINK (-) AT REAR ELECTRONIC MODULE *

Trunk Pin Switch SAME AS ABOVE AT REAR ELECTRONIC MODULE **

Parking Lamp BLACK/ L GREEN (-) AT HEADLIGHT SWITCH

Power Lock L BLUE/ORANGE 20 PIN CONNECTOR AT FRONT #201

Power Unlock L GREEN/ YELLOW ELECTRONIC MODULE ***

* This Circuit Requires A Pull Up Resistor To Prevent False Triggering. See Tech Notes For More Information. ** F.E.M. Is Located Under The Dash Panel. *** R.E.M.Is Located behind Passegner's Side Rear Quarter Panel. #201 - See Negative Pulse Door Lock Diagram

DOME LIGHT INFO: Ford's F.E.M. And R.E.M. Will Drop A Low Signal Across The Dome Light And In Most Cases Cause A False Trigger. To Eliminate This, Connect One Side Of 10 k Ohm Resistor To The Door Trigger wire and Connect The Other Side Of The Resister to 12 Volts.Alternate Wire: Use YELLOW/BLUE (-) At Under Dash Curtesy Lamp If Equipped. Does Not Require Pull Up Resistor. Use YELLOW (-) At Dimmer For Dome Light Supervision. HEADLIGHT INFO: This Requires The TAN/WHITE To Be Cut At The HeadLight Switch And A Relay Added To Send 1.2K Ground Through A Resistor To The Vehicle Side

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Need help with 2000 Ford Windstar Dome Li

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.