2006 infinity g35 wiring

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 2006 infinity g35 wiring (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

misterjimbo

Silver - Posts: 535

Joined: October 11, 2003

Location: Michigan, United States

Posted: December 10, 2009 at 3:47 PM / IP Logged

I could not find any info on this car.

no intelli key and non push button start

is it the same as the 2006 350Z?

can you integrate the window down feature on the aftermarket remote?

Thank you gents

Back to Top

KPierson

Platinum - Posts: 3,527

This member consistently provides reliable information

Joined: April 14, 2005

Location: Ohio, United States

Posted: December 10, 2009 at 6:03 PM / IP Logged

12 VOLT CONSTANT	WHITE/ BLUE (+)	IGNITION SWITCH HARNESS
STARTER	RED / WHITE (+) or WHITE/ RED (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	WHITE/ GREEN (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/ RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY /HEATER BLOWER 1	WHITE/ BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED / BLUE (+)	IN DRIVERS KICK PANEL, HARNESS heading to REAR of Vehicle
POWER LOCK	YELLOW (TYPE B) See NOTE *2	@ DRIVERS DOOR MODULE in DRIVERS DOOR
POWER UNLOCK	LIGHT BLUE (TYPE B) Requires Double Pulse See NOTE *2	@ DRIVERS DOOR MODULE in DRIVERS DOOR
LOCK MOTOR WIRE	PURPLE (+)	@ BCM, 16-Pin Plug Pin 30, See NOTE *4
DOOR TRIGGER	YELLOW (-) and PINK (-) Use both, See NOTE *3	@ BCM, WHITE 12 PIN PLUG, See NOTE *4	14301_G35-COUPE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	PINK (-)	@ BCM, BROWN PLUG, PIN 76, See NOTE *4
SLIDING POWER DOOR	N/A
HORN	GREEN/ BLACK (-)	@ STEERING COLUMN HARNESS
TACH	ANY WIRE NOT BLACK or WHITE/ BLUE	@ ANY IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	PINK/BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse Disarms
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

NOTES

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.

NOTE *2 TEST THESE WIRES WHILE TURNING THE KEY IN THE DRIVER DOOR KEY CYLINDER.

NOTE *3 THE DRIVERS DOOR IS A YELLOW (-) PIN 14, THE PASSENGER DOOR IS A PINK (-) PIN 10. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM

NOTE *4 THE BCM (BODY CONTROL MODULE) IS LOCATED IN THE DRIVERS KICK PANEL, THE BCM HAS 4 WHITE PLUGS AND 1 BROWN PLUG.

You can control the windows with extended (-) triggers on the lock / unlock wires.

Kevin Pierson

Back to Top

misterjimbo

Silver - Posts: 535

Joined: October 11, 2003

Location: Michigan, United States

Posted: December 10, 2009 at 6:14 PM / IP Logged

thank you sir.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2006 infinity g35 wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.