sunroof, remote starter

well i was thinking of hooking my sunroof on to my remote starter so then i could be able to open and close my sunroof using my remote. does anybody know how i could wire this up. it would be great because i can't figure out what i will need to do.

its a astrostart 2100 in a 2001 grand am gt

Use a DEI 529t across the motor wires, that's assuming your R/S has an aux output.

it has 4 different outputs. dont i need one that is in latched mode. because i have two that are pulse and another two that are for the dome light and trunk. what type of output do i need.

My apologies, I read your post wrong, you will need a 530t to close and vent. Make 1 wire "timed" (not latched it's safer ) for say about 7 seconds, this will get you round the "safety trap" if there is one, the roof stops, press that aux twice, it resumes. Use another pulsed to vent and open. Does your roof tilt or tilt AND slide. I've only ever done closing, where it didn't matter.

The module should do that.

bad link what about this one http://www.amazon.com/Galaxy-ACCWR-8-4-Roll-Up-Window-Module/dp/B00154784Q

I used the DEI 530t for my sunroof like howie mentioned above (unfortunately it was a few years ago and in my previous car...so I'm going by memory here). I hooked it up to my auxillary output on my alarm/remote starter. I believe I had it set to Validity output. So if I just pressed and released the button on the remote, the sunroof would vent. If I pressed and held the remote button until the sunroof started to move and then let go, it would open all the way because of the 530t's ability to do 1-touch up and down of the windows. So the sunroof would open until the 530t noticed it was open all the way, and then the 530t would turn off.