hooking up highs amp

Ok i really need help hooking my highs up right..

heres my amp im useing   http://soundtoyzaudio.com/index.php?act=viewProd&productid=353

FRONT

alpine componets  (6" and tweeter)

REAR

orion colbalt 6x9s SAYS there 3ohms

and have pair of massive tweeters

the 3 ohm 6x9s are thowing me off..

 I was going to hook front alpines comp.. to channel 1 and 2  stright + to +  and - to -        and twist the 6x9 and tweeter wires toghter  and run them stright + to + and - to - AND put them ---> 1 6x9 and 1 tweeter on channel 3 and 1 6x9 and 1 tweeter on channel 4 ... is this right or im i way off...   please help is there a better way to hook all this up?

looks like you are good up till u get to the 6x9 and tweeters. If you run the 6x9 and tweeter in SERIES, you will be ok. Correct me if I'm wrong (somone) but assuming the tweeter that is to powered together with the 6x9 is 4ohm, it would need to be ran in series for 7ohm load. If ran in parallel it would be 1.71ohm?

According to the amp's spec. it is only stable down to 2ohm stereo.

6x9 + >  - on tweeter + of tweeter > amp - of 6x9 > amp.

Make sure the tweeter has a capacitor, if not and you run full range out to it... POOOF! Time for a new tweeter.   

Don't concern yourself with the ohms on this drawing. This is how you hook two speakers in series.